4. 1. THE AIRSHIP(BALLOON): It is constructed by the use of
Composite fabrics. It is filled with helium gas.
2. TETHER: It is the rope tied to the balloon of MARS. It is simply a
Wire rope.
3. 3D STRUCTURE: SAILS, AXEL, RUDDER.
4. GENERATOR : Asynchronous generator is installed on the axel of
MARS.
5. WINCH: For fixing the balloon at ground and to adjust height of it.
(Balloon fixed on rotating drum at certain height)
6. Note : The filled helium is always keeps at 2 X higher than Systems
weight
Construction
5. 5
USE OF HELIUM GAS :
EASILY AVAILABLE,
NON-INFLAMMABLE,
NON TOXIC
Filling Helium Gas In MARS Balloon At Site.
10. 10
CONVENTIONAL WIND MILL MAGENN AIR ROTOR SYSTEM (MARS)
1. Installation :
2. It is less noisy
3. Higher & adjustable altitude
4. Mobile
5. It can be installed wherever needed
(Care should be taken near Airport)
6. Less Installation time & cost req.
1. Installation :
2. It Is noisy in operation
3. Less and fixed altitude
4. Immobile
5. Particular site conditions are necessary
6. More indicial time & cost req.
11. 1. Low cost electricity.
2. Wide range of wind speed
3. Natural resource of energy
4. Ability to install closer to power grid.
5. Can used like mobile since we can take it from one place to
another.
6. Ideal for off grid applications or where power is not
available.
7. Bird & bat friendly.
8. Lower noise.
ADVANTAGES
12. 12
1. Leakage of helium gas.
1. (Need to feel after every 6 month)
2. It cannot be installed near Airport.
3. As output power is dependent on
4. wind speed so, it gives varying output.
DISADVANTAGES
13. 13
The M.A.R.S. is suitable to produce the electric energy due
to its ability to use in the developing countries like us with
reduced infrastructure or in the areas of country where is no
infrastructure.
This approach of energy producing is also able to use on
ISLANDS, OUTLYING FARMS, during the NATURAL
DISASTER.
CONCLUSION