Contact professional rendering services expert for house rendering services in cement rendering & texture coating for domestic & commercial buildings. Get a quote Now!

1. A Preparation & Rendering Guide
by Mix Mud Render Specialists
© MIXMUD. All Rights Reserved.

2. No matter what sort of a structure it is it should radiate excellence. It can be achieved
by following a proper design procedure along with using great rendering techniques.
A small guide has been compiled for rendering surfaces.
• Basics
Attention to detail is an essential part of cement render in Sydney. For external
walls, rendering can be used as waterproofing along with adding an appeal to it
by using textures and colours. To highlight a single wall bold colours, textures, or
designs could be added.
Depth effect can be introduced to the structure by using a contrast of colours or
textures.
A few things should be kept in mind before rendering the walls:
• A proportionate mixture
• Thickness should be maintained
• An appropriate number of coats
• Attentive curing
• Surface Preparation
It is essential that the surface being rendered is clean for cement render in
Sydney or anywhere else. It needs to be free from dirt, oil, paint, dust, or any
such thing.
For bases like cement or metal frames, the surface should be prepared with a
“dash coat” before applying the render. Dash coat is a mixture of cement and
water. It is made to flick onto the wall surface and near the window and door
frames. This mixture provides a surface for the render to stick to.
© MIXMUD. All Rights Reserved.

3. A minimum wait of 24 hours is essential to get the desired result.
• Preparing the Mixture
The mixture should be prepared using great quality plastering sand. Agencies
that provide cement render in Sydney say that the materials should be mixed in a
proper ratio using the correct measurement of volume.
The mixture should be prepared on a hard and flat surface. A cement mixer or a
wheelbarrow work as well. A mixture says usable for 30-40 minutes. So, it is
advisable that only a small batch is made per use.
The first step to prepare the mixture will be to add up all the dry ingredients and
mix them until it has a uniform colour. Small portions of water will be added to
the dry ingredients. The mixture should seem semi-solid like putty.
In case the mixture turns out to be too dry or too wet, it should not be used.
© MIXMUD. All Rights Reserved.

4. • Application
As mentioned before a uniform thickness all over the surface is crucial. To ensure
that the thickness is really maintained wooden battens can be nailed to the wall.
The battens will be of the same thickness which will provide a clean edge to work
with. This is what the cement rendering services in Sydney also do.
To apply the render on the wall a steel float can be used. Layers can be added
until the desired thickness is achieved. Once that is done the surface can be
smoothed out.
If multiple coats are to be applied then each new coat will have to be dried for 3
to 7 days. Each surface will have to be scratched as well for the next coat to stick
to it.
• Finishing
For the final coat, there are a lot of finishes available in the market like:
• Trowel Finish- The final coat is skimmed using a wooden float for a smooth
surface.
• Sponge Finish- Considering the name, a damp sponge is used to give the surface
a sponge-like texture.
• Roughcast Finish- The final coat is flicked onto the wall and no retouching is
carried out leaving the surface rough.
• Bagged Finish- A damp hessian (a type of cloth) is used to add texture to the
surface. The texture will depend on the style of dabbing or rubbing.
Cement render in Sydney is one of the best ways to give a modern look to any
structure.
If you haven’t yet hired a rending service provider, contact the Mix Mud- Acrylic
rendering services specialist in Australia today. Get your rendering done by an expert at
better prices without compromising workmanship and quality.
© MIXMUD. All Rights Reserved.