This document describes a circuit designed to detect the exact location of a break in a power cord wire. The circuit uses a CMOS hex inverter CD4069 chip to generate a 1000 Hz audio signal. As a test probe is moved along the wire, the broken location can be identified by a change in the audio tone. The circuit operates on a supply voltage range of 3-15V and uses common components like resistors, diodes, and a BC547 transistor. It allows broken wires inside insulation to be identified without disturbing the casing.
2. INTRODUCTION
In our day to day life we use various electronic appliances
employing various complex components in there circuitry and
in the present era everyone is over dependent on electronic
gadgets.
Due to prolonged usage, the power cord wires are subjected to
mechanical strain and stress, which can lead to internal
snapping of wires at any point.
So we have built a circuit which can easily detect the exact
location of the broken wire and thus reduces unnecessary
expenses of the user.
2
4. OPERATION :
It is built using hex inverter CMOS CD4069. Gates N3 and
N4 are used as a pulse generator that oscillates at around
1000 Hz in audio range.
The frequency is determined by timing components
comprising resistors R3 and R4 and capacitor C1.
To detect the breakage point, turn on switch S1 and slowly
move the test probe closer to the faulty wire, beginning with
the input point of the live wire and proceeding towards its
other end.
4
5. COMPONENTS USED :
CMOS HEX INVERTER CD 4069 :
The CD4069UB consists of six inverter circuits and is
manufactured using complementary MOS (CMOS) to achieve
wide power supply operating range, low power consumption,
high noise immunity, and symmetric controlled rise and fall
times.
5
7. FEATURES :
Wide supply voltage range: 3.0V to 15V
High noise immunity: 0.45 VDD type
Low power TTL compatibility: Fan out of 2 driving 74L
Operating Temperature Range (TA) −55°C to +125°C
7
9. FEATURES :
High switching speed: max. 4 ns
General application
Continuous reverse voltage: max. 100 V
Repetitive peak reverse voltage: max.100V
Repetitive peak forward current: max. 450 mA.
9
10. BC547 TRANSISTOR :
The transistor is a component with 3 electric wires coming out
of it. They are named B (base), C (collector), and E (emitter).
It is an NPN Epitaxial Silicon Transistor.
10
11. Types of resistors used in the Circuit
47 ohm Resistor
1M ohm Resistor
560 ohm Resistor
220 ohm Resistor
11
12. CONCLUSION
Thus the circuit was made successfully which can easily detect
broken point in the wire inside the PVC jacket without
physically disturbing it.
This will make the circuit more compact and easy to handle.
The handy broken-wire detector can be taken anywhere and
everywhere and becomes less prone to damage.
12