Instructions and visuals on how to physically create your flappy dude from manila tagboard.

1. Physical Regions Foldable
Instructions may contain flappydudes.

2. Use entire sheet of manila
tagboard

3. Step 1 — Pinch in half on top and bottom

4. Step 2 — Fold both sides to pinch

5. Step 3 — Crease both folds

6. Step 4 — Measure 1 inch from
top

7. Step 5 — Mark 3 to 4 places top left, top right, and
top middle

8. Step 6 — Connect dots with a ruler and a pencil line

9. Step 7 — Cut on line only on the front to the edge and
stop

10. Step 8 — Fold up from
bottom

11. Step 9 — Pinch both bottom
corners

12. Step 10 — Draw line between
pinches

13. Step 11 — Cut to edge on front only

14. Step 12 — Fold up from bottom

15. Step 13 — Pinch both bottom corners

16. Step 14 — Draw line

17. Step 15 — Cut to edge on front only

18. Step 16 — Measure
flappydudes

19. Step 17 — Use that measurement to mark and draw
lines on the top section

20. Step 18 — Cut to edge on front only

21. Step 19 — Make the stand-alone heading by cutting
off the top 1 inch flappydudes along the fold only

22. Finished Flappydude Shell
Add some physical landform region information.