1. Model 5811 is a single zone door/window transmitter that is compatible with alarm systems that support 5800 series wireless devices. 2. 5811 has a unique serial number permanently assigned during manufacture that must be entered into the control panel during installation. 3. 5811 transmitters should be programmed as "RF" type in the control panel as required for UL installations.

1. 800-03928 2/09 Rev. A LATCH
ADEMCO 5811 E
OS
One Zone Door/Window Transmitter CL
O
Installation Instructions
T
REED
TE
Model 5811 is a single zone Door/Window
TA
RO
Transmitter, compatible with alarm systems that
support 5800 series wireless devices. 5811 has a ET
GN
unique serial number permanently assigned MA LE CASE
U NT VEAB TABS
during manufacture, which must be entered into MO MO CE
the control panel upon installation. Refer to the TO RFA
panel’s installation instructions for programming SU
details.
MOUNTING
Note: During programming of the control unit, HOLES
5811 transmitters should be treated as “RF” (i.e.
supervised RF) Type (mandatory for UL MOUNT 5811 TO
STATIONARY SURFACE 5811-003-V1
installations).
FEDERAL COMMUNICATIONS
MOUNTING
COMMISSION STATEMENTS: The user shall
Choose a mounting location for 5811 where the
device is stationary and the magnet is mounted not make any changes or modifications to the
to the moving part of the door or window. equipment unless authorized by the Installation
Before mounting 5800 permanently, conduct Instructions or User's Manual. Unauthorized
Go/No Go tests (see control’s instructions) to changes or modifications could void the user's
verify adequate signal strength from the authority to operate the equipment.
mounting location.
FCC / IC STATEMENT: This device complies
1. Mount using double-faced tape (supplied) with Part 15 of the FCC Rules, and RSS 210 of
by affixing it to the back of the unit and IC. Operation is subject to the following two
mounting the unit in place. Use screws conditions: (1) This device may not cause
(optional) if desired. Warning: Do not harmful interference (2) This device must
accept any interference received, including
mount unit in a location where
interference that may cause undesired
temperature may approach the freezing
operation.
point (32°F / 0°C).
SPECIFICATIONS
2. Mount the magnet (supplied) near the
Dimensions
alignment marks on the case (see Diagram).
2-1/8” (55mm) x 1-3/16” (30mm) x 1/4” (7mm)
BATTERY REPLACEMENT
Replacement Battery
1. Open housing by inserting a flat blade
Renata/Sanyo/Panasonic CR2025
screwdriver into latch and twisting gently.
2. Remove old battery cell.
3. Observe proper polarity (see diagram) then
WARRANTY INFORMATION
insert new battery so it is held by plastic
retaining clip. For the latest warranty information, please visit:
4. Engage the case tabs (see diagram), then
rotate the housing to close. Engage latch with www.honeywell.com/security/hsc/resources/wa
firm pressure.
2 Corporate Center Drive, Suite 100
REFER TO THE INSTALLATION INSTRUCTIONS P.O. Box 9040, Melville, NY 11747
FOR THE RECEIVER/CONTROL WITH WHICH Copyright © 2008 Honeywell International Inc.
THIS DEVICE IS USED FOR WARRANTY www.honeywell.com/security
INFORMATION AND DETAILS REGARDING
LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
Ê800-
Ê800-03928^Š
800-03928 2/09 Rev. A