A solar PV water pumping system - commonly known as a solar pump scheme - draws power from solar cell / modules to operate a solar pump yojna. Solar pannel power pumps use specially developed and energy efficient motor pump sets to achieve higher discharge which off sets the high initial cost. A solar pump dc consists of a number of solar PV modules connected in series - parallel combination to generate sufficient power to operate a motor pump. The solar PV modules are mounted on a metal frame in a manner that the mounting frame can be turned / tilted to ensure that the modules keep facing the sun throughout the day. The system does not have any storage battery since power generated is used directly then and there. The SPV array converts the solar energy into electricity which is used for running the solar pumps and controller. The pumping system can draw water from the open well / bore well or stream / pond or canal.
2. PRESENTATION OF GREENMAX
0.5HP SOLAR WATER PUMP
COMPONANT OF SOLAR PUMP
• SOLAR PANEL 500w (24v 250w x 2pcs)
• 0.5HP DC Solar Pump 1 Set
• 0.5HP MPPT Controller 24v 1 Set
• MS Structure for 2 Panels
• Cable 2.5mm (as per requirement)
• HDPE PIPE 0.75 Inch
3. DETAILS OF 0.5 HP SOLAR PUMP
1. Solar Module
2. Structure of Panel
3. Motor Pump
4. MPPT Controller
5. Cable
6. HDPE Pipe
7. Installation
4. SOLAR PV MODULE
SPECIFICATION
Maximum Power - 300w
Brand - Vikram/Waree
Cell Type mm - Polycrystalline
solar cell 156*156
Number of Cell - 72(6*12)
Manufacture Site - India
Open Circuit Voltage - 44v
Maximum Power Voltage (Vmp) - 36v
Short Circuit Current (Isc) - 8.235A
Optimum Operating Current - 8.20A
Power Tolerance - 0 +5w
Module Efficiency - 15.5%
Dimensions - 1677*1002*42
Weight - 20.21
Back sheet - Composite film
Frame Colour - Silver Anodized
Frame - Aluminium Alloy
5. Our Company Tie-up with Solar Panel
Manufacture Company, These are All
MNRE Approved and CE Certified
Companies
• WAREE ENERGY – MUMBAI –
200MW PLANT CAPACITY
• VIKRAM SOLAR – KOLKATTA –
100MW PLANT CAPACITY
8. SOLAR PUMP SPECIFICATION
MATERIAL SPECIFICATION
Wiring - (1) Copper Wire (2) Automatic Machine
Wiring
Shaft - Stainless Steel 304 shaft
Impeller - Stainless Steel 304
Bearing - NSK
Motor - Permanent magnetism, Three Phase
Outlet - Stainless Steel 304
Screw & Nut - Stainless Steel 304
Name Plate - Laser Marking
Rotor & Stator - Double Plastic Package , Motor Insulation
Efficiency - Improved 25% Then the Traditional
Alteration Current Motor
Software Start-up System - The Motor Start Up Placidly and
the Current is far Less Then Traditional Hardware Start up
technology