2. Which of the following categories does parts
retriever, screwdriver, wire cutter and long nose
plier belong to?
a.Cleaning tools b. Diagnostic tools
c. ESD Tools d. Hand Tools
3. To test a computer port, which of the following
computer hardware is recommended?
a. Anti-static strap b. Compressed air
c. Lookback adaptord. Multimeter
4. Which of the following tools will you use if
you are working with a slotted bolt?
a. Flat screwdriver b. Hex driver
c. Philip screwdriverd. Torx screwdriver
5. Which of the following instruments will you
use to tighten or loosen a six-sided bolt?
a. Flat screwdriver b. Hex driver
c. Philip screwdriverd. Torx screwdriver
6. What would you do if there were faulty or
damaged tools in your toolbox?
a. Clean the toolkit
b. Place anywhere
c. Remove in your toolkit
d. Store in the toolkit
7. What is the best tool for removing dust from
a keyboard?
a. compressed air b. compressor
c. duster d. spray
8. Which of the following is NOT a benefit of
tool and equipment preventive
maintenance?
a. faulty tools and equipment
b. protection of tools
c. safe conditions of tools and
equipment
d. systematic care
9. What will you do to properly store computer
hardware tools?
a. Keep inside the box
b. Layered the tools
c. Place on the board/toolkit and labeled
d. Remove Faulty tool
10. Which of the following does NOT describe
a successful maintenance program?
a. defines procedure c. unsystematic
b. controls hazard d. well-organized
11. How will you use the screw driver to tighten
a screw?
a. Pull the screwdriver
b. Push the screwdriver
c. Turn the screwdriver clockwise
d. Turn the screwdriver counterclockwise
12. Which of the following is the BEST way to
clean a desktop keyboard?
a. Use compressed air or small
handheld vacuum cleaner with a brush
attachment
b. Use glass cleaner and soft cloth
c. Use lint free cloth and isopropyl
alcohol
d. Use screwdriver and open the
13. Which of the following is NOT an acceptable
method of storing computer parts, tools, and
equipment?
a. Label and store computer parts in a
cabinet
b. Place on board or in a tool cabinet and
label the tools
c. Use bins in storing small parts
d. Use cable ties and place on the table
14. Which of the following is the BEST way to clean
a desktop keyboard?
a. Use compressed air or small
handheld vacuum cleaner with a brush
attachment
b. Use glass cleaner and soft cloth
c. Use lint free cloth and isopropyl
alcohol
d. Use screwdriver and open the
15. Which of the following statements is/are FALSE?
Statement 1: Over-tightening screws may cause screw to
get stuck on its holes
Statement 2: Turn screws clockwise to loosen screws and
counterclockwise to tighten screws
Statement 3: Stripped screws may still be used but with
care
a. Statement 1 only c. Statement 2
only
b. Statements 1 and 2 d. Statements 2 and
3
16. Evaluate the following statements then select the best
answer
Statement 1: Properly stored tools and equipment will be
easy to find when needed and are less likely to be lost.
Statement 2: Using bins for storing small parts is a good
practice on proper storage.
a. All statements are FALSE c. Only statements 1 is
TRUE
b. All statements are TRUE d. Only Statement 2 is
TRUE
17. Evaluate the following statements select the best answer:
Statement 1: It is important to use hex drivers that is larger
than a bolt being used
Statement 2: Always over-tight bolts to ensure the quality
of the thread
Statement 3: Hex driver comes in both 6 and 8 sided head
a. Only statements 2 and 3 are TRUE
b. All statements are FALSE
c. All statements are TRUE
d. Only Statement 1 and 2 are FALSE
18. What do you refer to as a computer
system's physical parts?
a. Hardware b. Operating Systems
b. Software d. Web Browsers
19. Which part is known as the "brain" of the
computer?
a. CPU b. Hard Disk Drive
c. RAM d. ROM
20. Which of the following computer hardware
does NOT belong to output devices?
a. Keyboard b. Monitor
b. Printer d. Speakers
21. Hardware devices can be classified into four
distinct categories, which of the following
devices is NOT considered as an input device?
a. Joystick b. Keyboard
c. Microphone d. Monitor
22. When you need to input data into your
computer, which of the following devices is
BEST used?
a. Keyboard b. Monitor
b. Printer d. Plotter
23. What program enables users to build
electronic report presentations and other
functions?
a. Language software
b. Presentation software
c. Network software
d. Spreadsheets
24. What does WWW stands for?
a. Whole Wide Web
b. World Wide Waze
c. World Wide Web
d. World Widen Web
25. When accessing information on the internet
there is always what we call website/webpage
address that is unique. What is the other word
used to describe this unique address?
a. Bookmarks c. Links
b. URL d. Web
browser
26. In understanding computer data, what is
the equivalent of 1 byte?
a. 8 bits b. 8 Bytes
c. Nibble d. Word
27. 37.What does the symbol means in a
flowchart?
a. Connector b. Decision
b. Process d. Terminator