Currently,New Updated KESS V2 FW5.017 Master is a super hot ECU Chip Tuning Tool,KESS V5.017 Supports online,no tokens limited and in the normal,the KESS V2 5.017 can work well without any problem,but if you met the problem like "wake up error",you can check this article and give this guide a shot.

1. How to fix kess 5.017 “Wake up
error “ ?
Written by : buyobdii.com

2. About KESS V2 5.017
KESS 5.017 is the new updated ECU Tuning Tool
For KESS V2 Master Tool,with many striking
features like below
1.No Tokens limited,100% Working!!!
2.No need disconnect with internet when you
use.
3.KESS V2 has 140+ .
4.Support EDC17 ECU.

3. KESS V2 FW5.017 Preview

4. Where to buy quality KESS V2 5.017
Mater ?
KESS FW5.017 Will be a useful Car ECU
Programmer tool and if you are looking for
kess 5.017 online,you can give buyobdii.com,
see here : http://www.buyobdii.com/kess-
v5017-firmware-support-online-added-140-
protocol-no-token-limited-p-1087.html

5. How to fix “Wake up error “

6. In the normal time,KESS V2 5.017 master can
work well without any problems,but if you
met the problem like below, pls don’t
worry,you can fix your problem by following
tips
http://www.buyobdii.com/

7. Fixing Method
1. If your Kess v2 fails to read out TF card
program or the program in the TF card is not
working properly,then pls format your SD
card,redownload software,unzip it and copy
all files into your SD card.
Note : Don’t directly copy the compressed file
to TF card; don’t create a new folder in
TF card and copy decompressed file into it.

8. 2. The chip is loose for a long time of use. If caused by
this problem,then you can fix by this way
1.Solder the chip once more to make it tightly connected
to the main
board.
2.Clean up the shrapnel on the card slot with a brush.
3.Lift up the shrapnel a little bit to make sure it can well
communicate with the TF card, if the card slot
shrapnel is not flexible enough.
4.Clean the TF card and then put it back to the card slot

9. 3. The four pins of chip are not soldered firmly
on the main board.
If caused by this problem,then you need to
contact seller you bought from to help you,or
you reflash the PU program, and then copy
and paste the software to the TF card again.