The document outlines proposed changes to an easel stand design. It suggests that the stand should be 4 feet wide to accommodate a 6 foot by 4 foot MDF panel. The groove holding the panel needs to be 9mm thick with adjustable screws to secure the panel. The side legs should be collapsible for easy setup and dismantling, and padding and clamps are recommended to prevent gaps between the panel and stand.
2. 0.5 ft 0.5 ft
4ft
6 feet *
4 feet
(H*W)
Panel
The Stand should
be 4 feet in width.
Kindly note we have
to incorporate a 6*4
feet MDF panel in it
so the height should
be able to
accommodate the
MDF panel
3. 9mm
The Grew in which the
MDF panel is hold
should be of 9mm
and should have
adjustable
Screw to tighten the
MDF Panel
4. The side legs of the
stand
Should be collapsible for
a quick setup.
5. Reduce the length of the
stand but maintain a
similar vertical angle for
the MDF panel
6. 2 Additional padding to
be provided at the
centre, so that there is
no gap between the
MDF panel and the
supporting legs of the
stand
8. The groove on which MDF
panel rests need to match
with the side legs of the
stand, so that there is no gap
between the MDF panels and
the side legs of the stand
9. Kindly use adjustable knobs, so
that it is easy to dismantle.