The document provides a step-by-step guide for glowing an LED in Proteus software, starting from opening the program to placing components such as LED and resistor. Users are instructed to select and place 5V power and ground terminals, make connections, and adjust resistor values as needed. Finally, it concludes by showing how to run the simulation and invites further inquiries via email.

1. Problem Statement: Glow an LED in Proteus.
1. Open Proteus ISIS.
2. Go to Pick From Library to add new component. (Make sure you are either in Selection Mode or
Component Mode)
Click On P [Pick From
Library] to add a new
component
Robolab Technologies’ Tutorials
Robolab Technologies’ Tutorials

2. 3. Type in Keyword or Component Name and select proper component from the available list.Type in
Animated LED if you want to see the colors in simulation (See the description of Component).
4. Click OK and place the component on the schematics by just Left clicking on the screen.
Type in Keyword or
component name
Robolab Technologies’ Tutorials
Robolab Technologies’ Tutorials

3. 5. To add series resistance of value 220 Ohm. Again Go to Pick from Library and type in Resistor in the
search bar. Select the resistance. Dont worry about the value of resistance, it can be varied afterwards.
6. Place the resistance near LED by left clicking on the screen.
Type in Keyword or
component name
Robolab Technologies’ Tutorials
Robolab Technologies’ Tutorials

4. 7. Power supplies-Go to Terminals Mode. You will have by default 5 Volts and 0 Volts available.Seclect
according to your needs.
8. Place POWER terminal near Anode of LED (To avoid clutter due to wires)
Click on [=] Terminals
Mode.And Select
POWER for by
default 5 volts and
GROUND for 0 volts.
Robolab Technologies’ Tutorials
Robolab Technologies’ Tutorials

5. 9.Place GROUND Terminal
10. Make the connection. (Forward biasing the LED)
Robolab Technologies’ Tutorials
Robolab Technologies’ Tutorials

6. 11. To change the value of resistance. Just hover over resistance till you see a red rectangle outline as
showed. Then double click on the symbol to open its properties Or right click on resistance and click Edit
Properties
12. Type in the required value in Resistance (OHMS) and click OK.
Robolab Technologies’ Tutorials
Robolab Technologies’ Tutorials

7. 13. To run simulation click on Play Button at the Left Bottom of screen.
TADA……!!!!!!!!!!!!!!!!
For more information, Contact us at info@robolabtechnologies.com.
Click on Play.
Robolab Technologies’ Tutorials
Robolab Technologies’ Tutorials