A microcontroller (MCU for microcontroller unit, or UC for μ-controller) is a small computer on a single integrated circuit. In modern terminology, it is similar to, but less sophisticated than, a system on a chip (SoC); an SoC may include a microcontroller as one of its components.

1. SUBMITTED TO: MR.HARINDER PAL SINGH SUBMITTED BY: GAURAV(MCA 3A)

2. It is a micro-computer. As any computer it
has internal CPU, RAM,IOs interface. It
is used for control purposes, and for data
analysis.
Famous microcontroller manufacturers are:
MicroChip , Atmel and more.

3.  Arduino is an open-source hardware and software company, project and user
community that designs and manufactures single-board microcontrollers.
Arduino can…
 Sense the environment by receiving input from variety of sensors.
 Affect its surroundings by controlling lights, motors, and other actuators.

4. Arduino Nano
Arduino Mini
TYPES OFARDUINO
Arduino Mega

6. It's composed of a few main components:
 The microcontroller board, which is usually a ATmega or ARM microcontroller
 The bootloader, which loads code from your computer on to the board
 The IDE, where you write C/C++-like code for the board
 The libraries, which provide high-level functions to you like writing digital values to pins
or reading analog input

7. A sensor is a device that detects and responds
to some type of input from the physical
environment.

8. A circuit to add additional electronics which directly fits into Arduino board.

9.  It is the environment where you can write Arduino
code, compile it and upload it to your Arduino or
Arduino compatible board.
 The Arduino IDE runs on the Java Platform.
 Arduino IDE basically has inbuilt functions and
commands

10. #define led 11
Void setup()
{
PinMode(led,Output);
}
Void loop()
{
digitalWrite(led,high);
Delay(1000);
digitalWrite(led,low);
Delay(1000);
}

11.  Inexpensive
 Cross platform
 Open source and extensible software
 Simple to use
 Low power consumption

12.  Home Automations
 3D Printers
 Robotics

13.  The Arduino board is open source so any one in the world can
make stuff using Arduino so you'll find tons of videos on
YouTube, udemy that will guide you.
 Should have a starter kit
 instructables.com

14.  Raspberry pie
 Beagle board
 Panda board
 CubieBoard

15.  https://www.arduino.cc/
 https://en.wikipedia.org/wiki/Arduino