1. A064_e
Draw-wire displacement sensors
wireSENSOR
Speed measurement on automatic abrasive cutting machine
Tiles and special bricks are processed according to Measurement system requirements
their type on automatic abrasive cutting machines. - Measurement range: 5 m (v=05 - 15 m/min)
The objective is fast throughput times with the best - Resolution: 5 pulses/mm
quality result. Here, the setting parameters for the
rotational speed, the circumferential speed of the Ambient conditions
cutting disk and the feed rate of the movable table - Temperature: 5 - 30 °C
are important. The table movement is acquired by a - Medium: dirt, water
rugged draw-wire displacement sensor with
incremental encoder. Measurement system setup
A digital tachometer calculates this speed and 1 x WDS5000-P501-C-E Draw-wire sensor
displays it. An analog output signal is available for 1 x TR1-WDS Deflection roller with mounting block
setting up a close-loop control circuit. The 1 x WEX-WDS Wire extension
displacement sensor is mounted protected in the 1 x TA202.022.Ax01 Tachometer display unit
ceiling section. The steel wire with wire extension is
joined to the moving table via a deflection roller. Reasons for the system selection
With the aid of the wire extension the actual - High accuracy and resolution
measuring wire and the sensor are protected from - Easy fitting and use
the dirty and wet environment. This guarantees a - Economical and compact housing version
clean wire intake and a long service life. - Numerous measuring ranges and possible
options
Principle
SPS
sensor display
wire extension cutting
disk
cutting
pulley wheel target
table/carriage
MICRO-EPSILON A member of micro-epsilon group.
Koenigbacher Str. 15 Tel.: 0 85 42/1 68-0 info@micro-epsilon.com Certified DIN EN ISO 9001 : 2000
94496 Ortenburg / Germany Fax: 0 85 42/1 68 90 www.micro-epsilon.com Modifications reserved Y9781064