Alcatel-Lucent Router in GNS3. It is a new vendor in GNS3.

1. Articles from Ciscoz.com
Alcatel-Lucent in GNS3
2014-12-28 02:12:59 admin
At last I have done it, i was trying to simulate Alcatel-Lucent Router in GNS3
from last few weeks. It was abit difficult to search everywhere because there
is no perfect tutorial which can be followed. After all lot of experimentation i
was able to implement it. There is a website http://brezular.com/ which helps
me, but here they did not specified how to run alcatel image in qemu. I think
they are using linux for this. First i tried linux, but did not get success. but let it,
now it is done.
Requirements :-
GNS3 1.2 —–> working
Alcatel-Lucent Image (Download TIMOS-SR-12.0.R6-vm.zip )
RAM 1920 MB for Qemu VM
Installation Steps:-
1. Extract the image form zip file.
then virtual disk sros-vm.qcow2 will be exrtacted
2. Now go to GNS3 1.2 —-> preferences —–> Qemu —–> Qemu VM —–>
New
Type the name
Now next screen , In this you have to give the RAM to Alcatel qemu, This
should be 1920 MB, i tried to change this value and it does not work for me, so
you have to make this value 1920 MB.

2. Next step you have to give the path for the .qcow2 file extension. Be sure
this path should be correct otherwise it will not boot.
Then change the adapters to 5 or 6 and type should be i82557b

3. Then go to GNS3 and drag alcatel
then start the alcatel, new black window will opened (Qemu)

4. then go to console of alcatel
Login : admin
password : admin
Now check card in the system
Card IOM3-XP-B is equipped in slot 1 of chasis but it is not provisioned. Thus
we must to provision it for the slot 1.

5. Now you have to configure the card 1 —-> then card-type —-> then mda 1
—-> mda-type
then go to the port and make it no shutdown
these are the basic steps which need to do every time you will start Alcatel-
lucent router.
If you have to check the config file in alcatel then type command, show bof
So this was the small tutorial to simulate Alcatel-Lucent in GNS3.
(Visited 457 time, 8 visit today)
admin
A networking buff, currently pursing Master`s in
Internetworking from University of Alberta. Having
knowledge of CCNA, CCNP (Routing & Switching), Red
Hat Linux (RHCSA, RHCE), VMware ESXI, NXS and linux
scripting. I have developed this site on the motto of
"Learning and Sharing", so as much i will grasp here in U of
A, you guys will be updated through a common boulevard
path i.e Ciscoz.com. So keep sharing your ideas and
enhance for knowledge on this Networking Platform.
More Posts - Website

6. Follow Me: