This document contains details and specifications for ceiling installation using Knauf products. It includes a bill of materials listing various ceiling components like metal furring, plasterboard, hangers, and connectors. A diagram shows the typical spacing of the supporting profile, hangers, and cross connectors used to suspend and connect the ceiling system. The drawing is labeled as detailing ceiling work for a project and includes details at scales of 1:1 for assembly.

1. 2400
1200
2400
118912001200
600600600600600600600600600
1117120012001200
Bracket for CD 60x27
Nonius Stirrup
for CD 60x27
Supporting Profile,
corrosion-protected
AQUAPANELâ
Maxi Screw
AQUAPANELâ
Joint Filler
Nonius-Hanger-Top
Nonius Stirrup
for CD 60x27
Nonius Pin
Knauf ceiling steel dowel
Knauf Plasterboard
U-Bracket
Metal Furring
Knauf Plasterboard
U-Bracket
Metal Furring
Saddle Clip
Angle Section
Flexible sealant
Nonius Hanger Top
Nonius hanger bottom
Cross connectors
Knauf mineral wool
Nonius hanger bottom
Basic ProfileCross connectors
Knauf mineral wool
CD Metal profil 60x27,
Tragprofil
CD-Metallprofil 60x27
Ankerfix Rapid Hanger
Steel Beam
Hanging Wire
Intersection Connector
Clamping Assembly
100
ca.
b b
ca. 250 a
ca.
150
c
spacing of supporting profile
spacing
ofbase
profile
spacing of suspenders
(anchors)
SPECIFICATION
Drawn by:
Approved by:Prepared by:
Revised by:
Prof.Dr. Ehab Ezzat Prof.Dr. Ehab Ezzat
Eng. Nelly HanyEng. Vivian George
Project: CEILING WORKING DETAILS - KNAUF
Sheet no.
Scale:
Multi
A-02
Detail 1 scale (1:1)
Detail 1
Detail 1
Detail 2
Detail 3
Detail 3
Detail 2 scale (1:1)
Detail 2 scale (1:1)
Detail 3 scale (1:1)
Detail 4
Detail 4 scale (1:1)
Detail 5
Detail 5 scale (1:1)
Detail 5 scale (1:1) Detail 5 scale (1:1)
D112 - D113 SYS.