lami-tube burst tester

1. Tube Burst / Leak Test
Model # P10D
Tube Burst Tester / Tube Leak Tester
Suitable to check
- Internal Pressure Resistance of Sealed Lami-Tubes.
- Leakages in a Sealed Lami-Tube (using optional fixtures / test stand)
Method of Operation :
- Burst Test : Internal Pressure is increased till failure of seal / laminate.
- Leak Test : Tube is pressurized at low pressure and held in water.

2. Technical Specs :
Digital Model : Model # P10D
Pneumatic Model.
Manual Start – Automatic Stop function at sample failure.
With Digital pressure sensor and Digital Indicator (Microprocessor Based)
With embedded Push Button controls on indicator panel.
With Dual Line, Backlit, Large LCD display for comfortable viewing.
With Peak Hold facility
With 5 test adopters (free of cost) as per your tube / cap samples.
With Multiple Measuring Units : Kg/cm2, p.s.i., kPa (User Settable, Menu System)
Range : 0 – 10 Kg/cm2
Least Count : 0.01 Kg/cm2
With Acrylic Tank for Operator Protection
With Optional, Mechanical Clamp to seal the open end of empty tubes.
Method of Operation (Empty or Filled Tube Burst Test):
1) For Filled Tubes, use as it. For Empty Tube Seal the tube with a Heat Sealer or Clamp the
open end with the mechanical clamp (optional accessory).
2) Attach appropriate tube adapter onto the Holder.
3) Screw tube into its adapter.
4) Invert Tube and Holder into the Burst Tank.
5) Press Start button.
6) The tube will be pressurized internally.
7) Adjust Flow / Pressure if required.
8) As soon as the tube bursts open, the air will be stopped AUTOMATICALLY. No need to
press the Stop button.
9) Note peak reading on Digital Display.
Method of Operation (Tube Leakage Test):
1) Seal the tube with an appropriate method.
2) Attach appropriate tube adapter onto the Holder.
3) Screw tube into its adapter.
4) Place a Glass Beaker inside the burst tank and fill it with water.
5) Invert Tube and Holder into the Burst Tank, such that the tube’s sealed end dips into water.
6) Press Start button.
7) The tube will be pressurized internally.
8) Adjust Pressure to 50% of known Burst Pressure or 0.2 Kg/cm2 (200 mbar).
9) Leakages (if any) will be seen as a constant stream of air bubbles.
Calibration Device :
• 4-20 mA MACS Calibrator Included.
Mili-Ampere Calibration Source / Current Loop Calibrator
For use with the above machine.
Utilities Required : a) Compressed Air @ 6-10 Kg/cm2 from your source.
b) Power : 230/110 Volts A.C., 50/60 Hz. Clean power.
Please specify power requirements while ordering.