Since LED panel light is coming into widely use, it is welcomed by consumers for the safety using, at the same time, it can replace existing traditional panel lighting with color consistency, multi- selectable color temperature, high brightness, long life, low energy consumption, environmental protection, etc. Then how can we install LED panel light? Here are my suggestions.

1. Some tips for you to finish a LED T8 installation
Since LED panel light is coming into widely use, it is welcomed by consumers for the safety
using, at the same time, it can replace existing traditional panel lighting with color consistency,
multi- selectable color temperature, high brightness, long life, low energy consumption,
environmental protection, etc. Then how can we install LED panel light
(http://www.atgelectronics.com/t8/) when we have bought, here I will take LED T8 as an
example.
1. Wire hanging
At first, we need to hang a wire in order to fix it on the ceiling module, then tighten the
screws (hanging wire factory has been installed.) Hanging wire vertically down the back of the
LED T8 hanging components. It is very easy for us to finish the installation. Consumers must pay
attention to ask manufacturers of standard accessories or optional.
2. Bracket -style
Firstly, we need to make a few screw holes in the ceiling, then slide- Ceiling LED T8 boxes
installed in the ceiling, fixed on three sides. Then return to the fixed panel lights inside the box a
good slide- mounted slide, and then on the fourth side to the side frame screws like. This is very
convenient, simple and time-saving.
3. Embedded
First of all, it is necessary for us to install sheet metal groove on the ceiling, and then secure
the back of the LED T8 (http://www.atgelectronics.com/tube/Flat-LED-Panel-Light.html)
bracket protruding pieces, then put the panel lamp, so that the bracket on the ceiling sheet metal
trough anastomosis can be fixed on the ceiling on. But for various ceiling thicknesses vary, so it is
necessary to adjust lamp height between the surface and the bracket, otherwise it will cause the
LED panel light installed above or below the ceiling surface after the phenomenon.
The above is my own opinions about how to install a LED T8, I think it will be better for in
installing any other LED panel light, and if you have any question, we may have further
communication.