4. For consistent results, always shake Aurora liquid before use, as catalyst may have separated from
monomer.
1. In mixing jar, first add one full vial (about 8ml) Aurora liquid. Then add one level scoop (about 30cc) Aurora
powder.
2. Mix immediately for 30 seconds. Allow an additional two minutes to gel.
3. Mold dough in hands to homogenize material until a nonsticky dough is produced that will adapt readily to the
model.
4. Coat the model with Liquid Foil.
5. Mold Aurora on the model to the desired tray thickness, not to exceed 3mm at its thickest point. Form the
handle on to the tray. Trim excess material with a knife. Save excess material in mixing container to use for next
tray.
6. Cure the material while on the model in a light cure unit (operating at 400500nm) for a minimum of three(3) minutes.
7. Trim excess with a bur.
Instructions for Use (Continued) Note:
Aurora dough can be stored in the tightly sealed mixing container away from light for approximately 24 hours.
Disposal
Dispose of unused material in accordance with local, state, and national legislation.