1. CHAPTER 6 BASIC PROCEDURES
Push CONDITION Push CONDITION to change the screen to the
marking
of function keys.
condition setting screen.
LASER MARKER
<< MARKING CONDITION >> SUNX
ＦＩＬＥ：００２ [ＴＥＳＴＤＡＴＡ２ ] HELP
GENERAL CHARACTER CAD OPERATOR
Condition number １
FILE
Character height･
5.00 [mm] Set line･････････ 1 ～ 30
Character width･･ CHARACTER
5.00 [mm] Marking shape Straight line
X Position･･･････ 0.00 [mm] SET FUNC
Font････ Original 3
Y Position･･･････
0.00 [mm] Bold････････････ 0.00 [mm] CONDITION
Char. interval･･･
5.00 [mm] Laser power･･････ 100 [%] SET LASER
Line interval････
5.00 [mm] Scanning speed･･･ 100 [%]
SET TRIG
Laser pluse cycle 100 [%]
IMAGE
COPY PASTE
FLOPPY
MARKING MODE
RUN TEST ＳＴＡＲＴ ＳＴＯＰ INDICATE ENVIRON
Set the marking Push Numerals for marking position and have ten
keys
position to X=
Indicated and then push symbols and numerals in the
-10.
order of
－ １ ０ SETTING
Ｘ position [mm]
－１０
７ ８ ９ ← →
４ ５ ６ DEL BS
１ ２ ３ CANCEL
０ ． － SETTING
LASER MARKER << MARKING CONDITION >> SUNX
ＦＩＬＥ：００２ [ＴＥＳＴＤＡＴＡ２ ] HELP
GENERAL CHARACTER CAD OPERATOR
Condition number １
FILE
Character height･
5.00 [mm] Set line･････････ 1 ～ 30
Character width･･ CHARACTER
5.00 [mm] Marking shape Straight line
X Position･･･････ -10.00 [mm] SET FUNC
Font････ Original 3
Y Position･･･････
0.00 [mm] Bold･･･････ Laser pluse cycle
Char. interval･･･ ･････
MARKIN [mm]
5.00 COPY
Line interval････ Laser
5.00 [mm] power･･････
Scanning
speed･･･

2. 0.00 [mm] 100 SET TRIG
[%] CONDITION
100 [%] IMAGE
PASTE SET LASER
100 [%]
FLOPPY
RUN TEST ＳＴＡＲＴ ＳＴＯＰ INDICATE ENVIRON
6-8