This document is a resume that summarizes the qualifications and experience of a mechanical design engineer. It outlines experience in designing components and systems for various products including rocket engines, gas turbine engines, cruise missiles, and military vehicles. Specific experiences mentioned include designing thrust chambers, hydraulic simulators, vehicle structures, and test fixtures. It also discusses experience in manufacturing support, production issues solving, discrepancy investigation, and test engineering.

2. Engineering experience spans across products such as Rocket Engines, Chemical Sensors, Cruise Missiles, Gas Turbine Engines, Missile Launch Systems, Ground Support Equipment, Test Equipment and Armored Military Ground Vehicles

4. Component design with a system focus

5. Demonstrated ability to learn quickly and work productively with multidisciplinary teams to obtain bottom line results

8. Oversaw the work of junior engineers, evaluated their work based on engineering principles, company, and professional trade standards.

9. Designed a ramp assembly for amphibious troop carrier vehicle. Designed the ramp structure and mounting provisions. Managed outside supplier and 2 BAE engineers for 3 remaining subsystems.

10. Designed and implemented an emergency release system for pneumatic door assist. Introduced into new vehicle production and as a retrofit kit.

11. Worked with manufacturing to evaluate designs for reducing cost and improving producibility.

13. Designed vibration test fixture for satellite avionics box. Required 3D adjustment for proper random vibration spectra input.

14. Managed the design introduction of an inherited product (NEDS) from Pratt & Whitney to Hamilton Sundstrand.

15. Integrated 3D models from the Hamilton Sundstrand facility in Connecticut into a master installation assembly for ground handling equipment in support of a satellite sensor program.

17. Rendered disposition of non-conformances and reported them to the on-site customer (US Navy).

18. Report and supporting analysis presented to USN personnel

19. Wrote detailed design and analysis justification for dispositions using 3D models, hand calculations and GD&T tolerance stack up analysis.

20. Participated on integrated product teams (IPT) to identify discrepancies.

22. Designed compressor housing made by centrifugal casting, reducing cost 20%.

23. Performed stress analysis and design optimization of a water dynamometer disk using Pro/E and Ansys.

24. Rendered disposition of non-conforming hardware; authorized to determine rework or scrap.

26. Set up test cell, coordinated and performed instrumented engine test collecting over 100 channels of strain gage, accelerometer, temperature and pressure data.

27. Set up test cell for reintroduction of older engine being redesigned for US Navy.