1. SESSION PLAN
Sector : Electronics
Qualification Title : Computer Systems Servicing NC II
Unit of Competency : Set-up Computer Networks
Module Title : Setting-up Computer Networks
Nominal duration : 48 hours
Learning Outcomes:
LO1. Install Network Cables
LO2. Set Network Configuration
L03. Set Router/Wi-Fi/Wireless access point/repeater configuration
L04. Inspect and test the configured computer networks
A. INTRODUCTION
This module covers the outcomesrequired in setting-upcomputers networksfor LANs and small-office home-office (SOHO) systems. It
consists of competenciesto install network cables, set network configuration,set router/Wi-Fi/wireless accesspoint/repeater
configuration as well as to inspect and test the configured computer networks.
B. LEARNING ACTIVITIES
LO1: Install Network Cables
Learning Content Methods Presentation Practice Feedback Resources Time
1. Network Design Discussion
Viewing
Multimedia
Listen to the
discussion of your
trainer on Information
Sheet 2.1-1 Network
Design and watch
Answer Self-Check
2.1-1
Compare to
answer key
Check 2.1-1
Video
Clip/PP
Presentation,
Information
Sheet, &
Self-check
1 hr.
2. 2. Basic Hand Tools
and Network
Materials
3. Personal Protective
Equipment (PPE) and
Occupational Health
and Safety (OHS)
and procedures
4. Cable Splicing
Self-study
Self-study
Discussion
Viewing
Multimedia
multimedia
presentation
Read Information
Sheet 2.1-2 Basic
Hand Tool and
Network materials
Read Information
Sheet 2.1-3 Personal
Protective Equipment
(PPE) and
Occupational Health
and Safety (OHS) and
procedures)
Listen to the
discussion of your
trainer on Information
Sheet to the In 2.1-4
Cable splicing and
watch multimedia
presentation
Answer Self-Check
2.1-2
Answer Self-Check
2.1-3
Answer Self-Check
2.1-4
Compare to
answer key
Check 2.1-2
Compare to
answer key
Check 2.1-3
Compare to
answer key
Check 2.1-4
Information
Sheet, Self-
check, & Key
Check
Information
Sheet, Self-
check, & Key
Check
PP
Presentation
Information
Sheet, Self-
check, & Key
Check
2 hr.
2 hr.
2 hr.
3. 5. Network Cables and
Cable raceway
installation
requirements
Demonstration
Discussion
Demonstration
Observe Trainer
Demonstration on
Cable splicing
Listen to the
discussion of your
trainer on Information
Sheet 2.1-5 Network
Cables and Cable
raceway installation
requirements
Observe trainer
Demonstration on
Network Cables and
Cable raceway
installation
requirements
Perform Task sheet
2.1.4 Perform Cable
Splicing
Answer Self-Check
2.1-5
Perform Task sheet
2.1-5 Install Network
Cables and Cable
raceway
Check
Performance
using
performance
criteria
checklist
2.1.4
Compare to
answer key
Check 2.1-5
Check
Performance
using
performance
criteria
checklist
2.1-5
System Unit,
Crimping
tools, Cable
tester, RJ45,
UTP wire,
raceway,
hand drill,
switch, and
router Wi-Fi.
Information
Sheet, Self-
check, & Key
Check
Crimping
tools, Cable
tester, RJ45,
UTP wire,
raceway,
hand drill,
switch, and
router wifi.
4 hr.
1 hr.
3 hr.
4. LO2. Set Network Configuration
1. Check Network
connectivity
2. Diagnose Fault or
problem in the
network system
Discussion
Viewing
Multimedia
Demonstration
Discussion
Viewing
Multimedia
Listen to the
discussion of your
trainer Information
Sheet 2.2-1 Check
Network connectivity
and watch multimedia
presentation
Observe trainer
Demonstration on
Check Network
connectivity
Listen to the
discussion of your
trainer on Information
Sheet 2.2-2 Diagnose
Fault or problem in
the network system
and watch multimedia
presentation
Answer Self-Check
2.2-1
Perform Task sheet
2.2-1Network check
connectivity
Answer Self-Check
2.2-2
Compare to
answer sheet
key Check
2.2-1
Check
Performance
using
performance
criteria
checklist
2.2-1
Compare to
answer sheet
key Check
2.2-2
Information
sheet, Self-
check and
key check
Video clip/PP
Presentation
System Unit,
router Wi-Fi
and switch
Information
sheet, Self-
check and
key check
Video clip/PP
presentation
2 hr.
2 hr.
3 hr.
5. 3. Unplanned events or
condition of Network
connectivity
Demonstration
Self-Study
Observe trainer
Demonstration on
Diagnose Fault or
problem in the
network system
documentation
Read Information
Sheet 2.2-3
Unplanned events or
condition of Network
connectivity
Perform Task sheet
2.2-2 Diagnose Fault
or problem in the
network system
Answer Self-Check
2.2-3
Check
Performance
using
performance
criteria
checklist
2.2-2
Compare to
answer key
Check 2.2-3
Documentati
on System
Unit, Router
Wi-Fi, switch
and cable
route
Information
Sheet, Self-
check, & Key
Check
2 hr.
1 hr.
LO3: Set Router/Wi-Fi/Wireless access point/repeater configuration
1. Configure Client
Device system
settings
Discussion
Viewing
Multimedia
Demonstration
Listen to the
discussion of your
trainer on Information
Sheet 2.3-1 Configure
Client Device and
watch multimedia
presentation
Observe trainer
Demonstration on
Configure Client Device
system settings
Answer Self-Check
2.3-1
Perform Task sheet
2.3-1Configure
Client Device
Compare to
answer key
Check 2.3-1
Check
Performance
using
performance
criteria
Information
sheet, Self-
check and
key check
Video clip
System Unit,
Router Wi-Fi,
switch and
cable route
2 hr.
2 hr.
6. 2. Configure Local Area
Network
3. Configure Wide Area
Network
Discussion
Viewing
Multimedia
Demonstration
Discussion
Viewing
Multimedia
Listen to the
discussion of your
trainer on Information
Sheet 2.3-2 Configure
Local Area Network
and watch multimedia
presentation
Observe trainer
Demonstration on
Configure Local Area
Network
Listen to the
discussion of your
trainer on Information
Sheet 2.3-3 Configure
Wide Area Network
Answer Self-Check
2.3-2
Perform Task sheet
2.3-2 Configure
Local Area Network
Answer Self-Check
2.3-3
checklist
2.3-1
Compare to
answer key
Check 2.3-2
Check
Performance
using
performance
criteria
checklist
2.3-2
Compare to
answer key
Check 2.3-3
Information
sheet, Self-
check and
key check
Video clip/PP
Presentation
System Unit,
& switch
Information
sheet, Self-
check and
key check
Video clip/PP
Presentation
2 hr.
2 hr.
2 hr.
7. 4. Configure Wireless
set-up
Demonstration
Discussion
Viewing
Multimedia
Demonstration
Demonstration
and watch multimedia
presentation
Observe trainer
Demonstration on
Configure Wide Area
Network
Listen to the
discussion of your
trainer on Information
Sheet 2.3-4 Configure
Wireless set-upand
watch multimedia
presentation
Observe trainer
Demonstration on
Configure Wirelessset-
up
Perform Task sheet
2.3-3 Configure Wide
Area Network
Answer Self-Check
2.3-4
Perform Task sheet
2.3-4 Configure
Wireless set-up
Check
Performance
using
performance
criteria
checklist
2.3-3
Compare to
answer key
Check 2.3-4
Check
Performance
using
performance
criteria
checklist
2.3-4
System Unit,
Router Wi-Fi,
switch
Information
sheet, Self-
check and
key check
Video clip/PP
Presentation
System Unit,
Router Wi-Fi,
switch
2 hr.
2 hr.
2 hr.
8. 5. Configure
Security/Firewall/Ad
vance Settings
Discussion
Viewing
Multimedia
Demonstration
Listen to the
discussion of your
trainer on Information
Sheet 2.3-5 Configure
Security/Firewall/
Advance Settings and
watch multimedia
presentation
Observe trainer
Demonstration on
Configure
Security/Firewall/
Advance Settings
Answer Self-Check
2.3-5
Perform Task sheet
2.3-5 Configure
Security/Firewall/
Advance Settings
Compare to
answer key
Check 2.3-5
Check
Performance
using
performance
criteria
checklist
2.3-5
Information
sheet, Self-
check and
key check
Video clip/PP
Presentation
System Unit,
Router Wi-Fi,
switch
2 hr.
1 hr.
LO4: Inspect and test the configured computer networks
1. Final Inspection
configuration to
computer network
2. Check/safe
Computer network
operation
Self-Study
Self-Study
Read Information Sheet
2.4-1 Final Inspection
configuration to
computer network
Read Information Sheet
2.4-2 Check/safe
Computer network
operation
Answer Self-Check
2.4-1
Answer Self-Check
2.4-2
Compare to
answer key
Check 2.4-1
Compare to
answer sheet
key Check
2.4-2
Information
sheet, Self-
check and
key check
Information
sheet, Self-
check and
key check
2 hr.
2 hr.
9. C. ASSESSMENT PLAN
WrittenTest
Demonstration with oral questioning
D. TEACHER’S SELF-REFLECTION OF THE SESSION
The trainee’swhere given a copy of the competency learning module to provide them with their own pace of training and themselves
to be prepared for institutional/ National Assessment for CSS Qualification.
At the end of the module a job sheet is performed by the trainee’s that will summarized all the knowledge, skills and attitude they
acquired.
Prepared by: ENGELBERT N. CAGAMPANG
Trainer
