This PPT is all about my personal experience at Electronics industry during internship ans its deals about working of A-I department of Electronics industry.
3. EYELET
• it help to form a mechanical solder joint that increases
circuit reliability especially where high current involved
• Prevent pcb from tearing out where cord thongs or
fasteners are inserted
• Clinching angle should be 30~45
• Pressure should be 5-6 kgf/cm^2
• Eyelet dividing into 6 part
4. JUMPER
• Conductor that get soldered between two part on board
• To correct a defect or implement the change after the board
has been defined or assembly
• Resistance is normally much greater
• Clinching angle 15~30
• Pressure:-5-6 kgf/cm^2
• Clinching lead
• length:-1.2 to 1.8 mm
5. AXIAL MACHINE
• It is used for inserting AXIAL COMPONENT in pcb
• AXIAL COMPONENT comes from the sequential machine
• For different pcb different program are given
• Axial component are clinched
• Clinching angle30~45degree
• Pressure 5-6kgf/cm^2
6. SEQUENTIAL MACHINE
• Used for making sequence of axial component for axial
machine
• It work on different program for different type of sequence
needed
• It have 120 feeder line to store component
Feeder line
7. RADIAL MACHINE
• Components with wire leads are generally used on through-
hole boards. ... The parallel leads projecting from a single
mounting surface gives radial components an overall "plugin
nature", facilitating their use in high-speed automated
component insertion ("board-stuffing") machines
INSERTION
FEEDER LINE
8. MMT (PIN JIG)
• It is mainly used to find empty space or missing component in
pcb.
• It is formed with needle like structure if any component in pcb
is missing the needle(pin) will fall down
• For different pcb different module are used
9. Tools used
It is mainly used for
measuring the clinch angle
of component
it is mainly used to
measure the clinch length
of the component
10. AI-FG AREA
• It is jut like store used to store the pcb after
testing with mmt(pin jig)
• After this it is sent to MI or SMT
