The Evacuation Chair is made of steel & aluminium alloy with built-in pull through handles for easy handling. It is possible to take the chair upwards the stairs while patient is sitting and slide down the chair while a patient sitting is on the chair by operator The chair have four wheels out of which two should be fixed of maximum 150x35 mm and two with pivoting type maximum 100x35 mm. The evacuation chair have provision to be mounted to the rear door of any vehicle/wall support/building walls etc The weight of the evacuation chair 17Kgs. The patient seat and headrest of the chair can adjust, removable and washable and are made of nylon material The chair have a sliding system which allows the operator to control descent of the chair on staircases without having to support any weight. The chair have the provision to take the patient glide over the staircase with a high standard of safety and without requiring any effort by only single person The chair have the provision to fully fold it by single person only and all locks in the chair should be marked in colour other then the colour of the chair The evacuation chair have integrated wheel brakes and 2 belts with similar standards as those of chair for safety The load capacity of the wheel chair is 150 Kg. The physical dimensions of the wheel chair should be: Height Open – 1350 mm, Height Folded – 980 mm Width – 480 mm, Length – 1150 mm The chair must comply with Medical Device Directives (93/42/EEC) having the CE mark The chair is manufactured in an ISO 13485 and ISO 9001:2008 certified facility