Petrol engine water pump start operating procedures for 2in /3in /4in.

1. How to start a gasoline water pump?
For 2in /3in /4in
Caution: never attempt to operate the pump without priming water, or the
pump will overheat.
Remove plug.
Fill water and Install plug.

2. Check the fuel level by opening the tank and visually inspecting.

3. Check engine oil. Ensure the Pump is on a level surface.
Running the Engine with a low oil level can cause engine damage.

4. Turn the engine switch to the ON position.

5. Rotate the fuel valve lever to ON position (to the right). Push the air choke
lever to the CLOSE position out to close the choke(to the left).
Hold the frame by the left hand. Grasp the recoil starter handle and fast pull
it until the engine starts. Return the handle slowly by hand.

6. Immediately push the choke lever to the OPEN position (to the right) as the
engine warms up.
If the engine still does not start, push the Air choke lever to the middle
position and then try start again.