The document discusses the use and maintenance of collector rings, also known as slip rings or conductive rings. Collector rings allow the transmission of signals and electrical energy to rotating components. They are commonly used in motors and other applications involving rotating parts. Regular maintenance is important to clean dust and oil from the slip ring surface. Proper contact between the slip ring and brush is also important to ensure good electrical connection and prevent excessive wear.

1. cablesreel.com
Just another WordPress site
Menu
Collector ring use and routine maintenance
Leave a reply
Collect or ring , also known as conduct ive ring , slip ring . It is a communicat ion , t he t ransmission signal and t he elect rical energy t o t he
rot at ing body member . St eel wear ring collect or good mechanical st rengt h , it is most ly due t o t he polarit y difference caused by t he
wear on t he slip ring synchronous mot or larger . St eel and can be processed int o complex st ruct ures , is not only a mat erial but also
prone t o Him reasonable price , so widely used , including hydro , including lower circumferent ial speed synchronous mot ors.
Use collect or slip ring : collect or ring plays input / out put current and commut at ion role in t he mot or , slip ring direct ly affect s t he
degree of wear and mot or life .
First , t he copper ring around t he bronze finish , high hardness, resist ance, and wear resist ance.
Second, t he insulat ing mat erial select ion and E-glass fiber clot h impregnat ed wit h epoxy resin laminat e molding cast ing , good insulat ion
propert ies, good compressive shock , resin oil, ant i-oxidat ion , heat aging propert ies.
Third, t he special specificat ions can be quickly developed , support ing any model home and abroad.
When collect or rings also need regular maint enance in normal work, t o prompt ly clean up and check t he mot or , open observat ion window
cover and dust discharge hole cover should Baji ring room cleaned. If t he slip ring surface dust or oil, gasoline soaked rag can be used t o
dust , wipe t he oil , volat ile gasoline t o be allowed t o drive aft er . For mot or operat ion should always observe t he size of t he brush spark
, check t he brush , set t he wear ring surface.
PDFmyURL.com

2. Mat t er in t he cleaning of t he collect or ring Not e : t he cont act surface t o be processed int o t he corresponding arc brush and collect or
ring t o ensure good cont act ( t he cont act surface is not less t han 75% of t he t ot al area ) . When working wit h fine sand clot h fixed
collect or ring surface , t he brush simulat ion condit ions t o t he desired arc grinding on emery clot h .
This entry was posted in Uncategorized and tagged collector rings, collector slip ring on January 7, 2014.
← Slip ring select ion and reasonable prices
Leave a Reply
You must be logged in t o post a comment .
Searc h
REC ENT POS T S
Collector ring use and routine maintenance
Slip ring selection and reasonable prices
The use of conductive slip ring
Applications slip ring on the radar antenna
Tips slip ring
REC ENT C OMMENT S
PDFmyURL.com

3. Mr WordPress on Hello world!
ARC HIVES
January 2014
December 2013
November 2013
October 2013
September 2013
C AT EGORIES
Uncategorized
MET A
Log in
Entries RSS
Comments RSS
WordPress.org
Proudly powered by WordPress
PDFmyURL.com

4. PDFmyURL.com