The document describes the steps for identifying objects in Quick Test using smart identification. The steps are to select the environment, select mandatory properties for each object, select whether to enable smart identification, select base and optional filters, identify objects using mandatory properties, determine if objects are identified, execute steps, and determine if additional identification is needed. The process ends by executing steps or returning a run error.

3. Quick Test > Tools >
Object Identification
Select Environment
For each object
Select Select Required/
Select Assistive
Mandatory go with default
Properties
Properties Ordinal Identifier
Repeat Want End
Smart NO
Smart
Identific
Identificat Enable Smart
ation
NO ion while YES Identification
Enabled
recording
?
?
YES
Select Base Select Optional
Select
Filter Filter
‘Configure’
Properties Properties

4. QTP Test and
Associated Object
Start Run Repository
Identify Object
NO Use
Using Object Object YES Execute
Mandatory Identified Assistive Identified
? ? Steps
Properties Properties
YES
Execute NO
Steps SOI Enabled While
Recording
YES
Want to enable SOI
NO
SOI Enabled
during run Session While Running
YES YES
Disable SOI
Ignore Test Objects & Use
NO during run
session SOI Base filter Properties
Execute Steps YES Object Use SOI NO Object YES Execute Steps
Identified
with warning Identified Optional Filter ? with warning
?
Properties
NO
Use Mandatory, Object YES Execute
Identified
Assistive & Ordinal ? Steps
Identifiers
NO
Run Error