Sharp edges are not acceptable. The corner radius should be at least 5.0mm.
Sufficient front and back end discard is to be given, so that no piping and powder or slag entrapment is there in the billets.
Billet length should be as per P.O.
2. precaution POINTS
• Sharp edges are not acceptable. The corner
radius should be at least 5.0mm.
• Sufficient front and back end discard is to be
given, so that no piping and powder or slag
entrapment is there in the billets.
• Billet length should be as per P.O.
• Both end of the billets, should be cut through gas
cutting or band saw cutting with proper finish.
• Straightness should be 4mm/meter maximum. It
should be measured at one single curve only.
• Buckles in the middle and end of the billets are
not allowed
10/31/2019 2
www.ambicasteels.com
3. Southand
LatinAmerica
Customers Served
137
Countries Served
7
North
America
Customers Served
43
Countries Served
2
Ambica’spresencearoundthe world
OURPRESENCE
AmbicaSteelsisoneofthemostupdatedstainlesssteelcompaniesintheworld,employingarangeof
modernsteelmakingtechnologies.
Peru
Lima
Colombia
Cali
USA
Houston
Our Prominent
Customers
www.ambicasteels.com