PEEK or Polyetheretherket one is a semi-crystalline thermoplastic which is generally utilized as a part of designing applications. We can state that it is an awesome decision for seals. It is essentially required when the necessities lay outside the temperature scope of PTFE. It is perfectly suited in environments with temperatures between -70 F to 600 F and additionally it can't be influenced effortlessly by constant contact with steam and heated water. It is additionally harder than PTFE.

1. W: www.moulds.asia T: +886-4-2359-9288 F: +886-4-2359-9299

2. PEEK or Polyetheretherket one is a semi-crystalline thermoplastic which is generally
utilized as a part of designing applications. We can state that it is an awesome
decision for seals. It is essentially required when the necessities lay outside the
temperature scope of PTFE. It is perfectly suited in environments with temperatures
between -70 F to 600 F and additionally it can't be influenced effortlessly by constant
contact with steam and heated water. It is additionally harder than PTFE.

3. When it comes to peek bushing, they are commonly low rubbing, lightweight, and can
act naturally greasing up. Most importantly, they are widely accepted and well-known
due to they are less expensive and have a longer lifespan. In general, the greater part
of the polymer heading and bushings are produced using a type of PEEK, PTFE, Nylon,
or UHMW PE.

4. The significant purposes for the prominence of peek molding is that they give a decent
adjust of chemical, warmth, and wear protection, and adaptable with regards to
assembling. Fundamentally, the lower the K factor, the safer the material is to wear.
The K factor for PEEK is more noteworthy than that of PTFE and Nylon, yet it offers
other unrivaled qualities.

5. Aside from that PEEK has different characteristics too, for instance, thermal stability.
Essentially, friction brings about warmth, which can make basic parts warm up, as well
as to misshape. On the off chance that a bearing or bushing will be presented to high
temperatures, or to shifting temperatures, at that point the straight coefficient of
thermal expansion (CTE) ought to be as little as could be allowed.

6. It simply meansthe bearings and bushings made of PEEK aren't liable to so much
thermal deformation as those made of PTFE, UHMW PE, or nylon. To put it plainly,
peek molding has a high greatest working temperature joined with unrivaled thermal
stability. Truth be told, it remains an astounding alternative while choosing a material
for a bushing or bearing. To avail, these products, you can directly contact the
suppliers online. They offer it at a low price with the best quality.

8. MING-LI PRECISION STEEL MOLDS
CO., LTD.
No. 13,36 Rd., Taichung Industrial Park,
Taichung 407, Taiwan R.O.C. 407648
Tel: +886-4-2359-9288
Fax: +886-4-2359-9299
Mail: marketing@mingli-molds.com.tw
Sales contact:
Karl Wu (Ext. 23)
Mail: karl@mingli-molds.com.tw
http://www.moulds.asia/