"LLMs for Python Engineers: Advanced Data Analysis and Semantic Kernel",Oleks...
PermaClean 100
1. PERFORMACE TESTING
TEST
M E T HO D
DUR ATION
RESULT
Impact Resistance
ASMT D-2794
7 days
80 inch-pounds
Recoat - 140°F, Elcometer
ASTM D-4561
24 hours
OK
Adhesion, X-Cut
ASTM D-3359
7 days
5A
5% Salt Water @ 120°F
Immersion
10,500 hours
No Effect
120°F Water Immersion
ASTM D-714
24,000 hours
No Effect
120°F 25% NaOH
ASTM D-714
24,000 hours
No Effect
Salt Spray 5% NaCl
ASTM B-117
Non-scribed
24,000 hours
No Effect
Scribed
10,500 hours
6 Rating
Induron Coatings Inc.
3333 Richard Arrington Jr. Blvd N
Birmingham, Alabama 35234-2303
Phone: 205-324-9584 · 800-324-9584 · Fax: 205-320-5220
induron.com · Email: info@induron.com
Coat it and Forget it.
PermaClean 100
2. INDURON PROTECTIVE COATINGS PERMACLEAN 100
COAT IT AND
FORGET IT.
A field inspected project using Induron’s PermaClean 100 provides these advantages:
I Verification of specified surface cleanliness and anchor profile
I Solvent free system eliminates VOC’s, HAP’s and the possibility of solvent entrapment
With Induron’s Ceramic Epoxies
we’re ready to “Put our money
where our mouth is” with an
unprecedented 15 year warranty
for immersion service in water
tanks.
How is this possible you ask? Because
we have over 30 years of experience with
ceramic epoxies in water tanks, sanitary sewage
and other immersion exposures with no documented
failures on substrates that have been abrasive blasted with grit.
All of our ceramic epoxies use the same proprietary technology
that’s coated literally thousands of miles of sanitary sewage
pipe and hundreds of water tanks.
To offer this 15 year warranty we have to eliminate as many
variables as possible that can affect the service life of the
coating system. Most of the variables can be eliminated by
proper inspection of field surface preparation and painting.
Some of the variables are:
I Peened surfaces
I Oils, greases, mud and other contaminants on the
surface from fabrication, transportation and job site
staging prior to coating
I Carbon deposits left from blasting with steel abrasive
I Prime coats becoming hardened and chalked due to
extended exposure to UV
I Solvent entrapment caused by high film build,
cold weather &/or poor ventilation
I Unrivaled film build minimizes the risk of holidays(pinholes) and improves edge protection with up to 50
mils in a single coat.
I Absolute minimal undercutting - Where pinholes occur, the corrosion cell is limited and the surrounding
substrate is protected.
I Coatings applied immediately after surface preparation
I No chance for intercoat delamination
I Can be returned to service in 72 hours.
I A-Rated for cathodic disbondment.
I Ultra-Low Permeability keeps water away from your substrate.
PermaClean Application
PermaClean 100 has a metric perm rating well under 1.0.
Induron ceramic epoxies have performed well over the last 30 years, that’s why we’re willing to warrant our
ceramic epoxies for up to 15 years. We know from experience they’re going to last longer than that.
If you’re ready to put a coating system inside and out on your tank that will last so long we’ll have to remind
you that you specified it, give your local Induron representative a call.