The document provides instructions for making a pinhole camera from a Pringle tube in 6 steps. The steps include cutting the tube in half, creating a circular opening using a compass, lining the inside with black paper, closing one end with tracing paper and securing it with a rubber band, and wrapping the outside in foil. The completed pinhole camera worked as intended.

1. Making A Pinhole camera from a Pringle tube! By Michael McCauley

2. WE USED.... Half Pringles tube Black Sugar paper Tracking paper Foil Elastic band Scissors Masking Tape

3. 1 st Step First we had to cut the Pringles tube into two halves because we only needed one half which was the bottom half.

4. 2 nd Step Then we drew a circle on the sugar paper and cut the circle out in order to place it in the Pringles tube and used blue tac.

5. Next we mad a hole in the Pringles tube at the tin bit using a compass in order to see the hole if not how else can we see it. The hole in the Pringles tube. 3 rd Step

6. 4 th Step Next we covered the inside of the tube by covering the inside of the tube with black sugar paper all around inside.

7. 5 th Step After covering, we then closed the open end with tracing paper and secured it tightly with a elastic band.

8. 6 th Step Finally we wrapped the Pringles tube with foil so there is a good look and it would cover the masking tape as well as the Pringles cover.

9. That’s how we got our pin hole camera! Which Worked Fine!