This document provides a tutorial for disassembling an iPhone motherboard, detailing each step from turning off the device to removing various components like the SIM drawer, screen, and logic board. It warns that replacing the logic board deactivates the Touch ID functionality unless specific steps are taken during installation. At the end, it mentions the option to reassemble the parts by reversing the disassembly process.

1. Here’s How to Dissemble Your iPhone
Motherboard Repair Parts
Remove or replace the logic board in your iPhone according to the
instructions provided in this tutorial. Please keep in mind that each
iPhone's logic board and Touch ID fingerprint sensor are factory-linked;
thus, changing the logic board will deactivate Touch ID unless you install
a replacement home button correctly connected to your new logic board
throughout the process.
Step 1
First and foremost, you must power off your iPhone to remove the
motherboard.

2. Step 2
The SIM ejector should be inserted into the little hole in the drawer,
situated at the bottom, left edge of the iPhone. By applying slight
pressure on the SIM drawer, it will automatically eject, and you will
remove it.
Step 3
In less than 2 minutes, the SIM drawer is removed from the computer.
Step 4
Then, using your hairdryer, schedule many 20- to 30-second heating
sessions, one after the other. The screen tightly adheres to the frame
with extreme force! If you encounter any difficulties over the following
few procedures, do not be afraid to take your time and reheat the Apple
Spare Parts Wholease rather than risk damaging it.

3. Step 5
To begin detaching the screen, we suggest that you place the black clamp
at the bottom of the screen. Along with the pressure applied by the pliers,
gently insert an opening pick to leverage and create a small opening.
Once the pliers are in position, remove the opening pick gently.
Step 6
To finish peeling off the Best Cell Phone Glass Repair screen, carefully
glide the opening pick around the edge of the screen until it is completely
removed. In contrast to prior generations, the screen does not protrude
at all because of the square frame on which it is mounted. As a result,
things are weakened.
Step 7
Then remove the six tri-wing screws that have been circled in green. Then
you may take off the metal plates that we’re protecting you. Please
detach the battery cable first, using the nylon spatula, before eliminating
the possibility of a short circuit occurring later on.
Step 8
Finish by removing the internal speaker cord from the computer.
Step 9
The iPhone screen is a distinct piece that has been partly dismantled.
Step 10

4. Remove the four screws highlighted in green using the tri-wing
screwdriver you previously used.
Step 11
Maintain your grip on the pliers while you remove the second metal plate.
Step 12
Disconnect the SIM card cord from the computer.
Step 13
All of the connections connecting to the top of the motherboard will need
to be disconnected at this point. Begin by detaching the two wires that
are superimposed from the back camera.
Continue by removing the Face ID and flash cords from their connectors.
Step 14
Remove the screw at the top of the iPhone.Two cruciform screws are
circled in blue on the diagram. The orange circle indicates the location of
the rivet screw.
Step 15
Heat the black protection and shielding covering the bottom of the
motherboard for a few seconds with a hairdryer to ensure it is scorched.
Fold it back on itself to release the cord that connects to the volume
button.

5. Step 16
The nylon spatula may be used to gently raise and pull out the
motherboard once it has been gently lifted and pulled out.
Step 17
The iPhone motherboard has been released. Replace it with a refurbished
motherboard by following the instructions in this free tutorial.
Conclusion
If you need to reassemble your iPhone Motherboard Repair Parts, just
follow the steps below in reverse order.
Contact Us
Parts Fixit
Email : info@partsfixit.com
Website: https://www.partsfixit.com/