Hướng dẫn sử dụng BEN6220K_eng

1. USER MANUAL
MODEL: BEN6220K
MODEL BEN - 6220K
SPECIFICATION
PANEL FUNCTION
Resolution 900TVLs
Focal Length
IR
Vision
Dimensions (D)9.5 x (H)6.5cm
Indoor / Day - Night
36 LEDs
IR distance 15 - 20m
Image Sensor
3.6mm - 6mm optional
1/3'' Image Sensor Cmos
Cover
LED support IR Cut
Light Sensor
Len
INSTALLATION NOTICES WIRING DIAGRAM
1. Electrical Safety
For safety in instalation, ensure that specification of power supply suitable with this written
on label.
Don’t plug out when instalation haven’t finished
2. Delivery Safety
Cameras are fragile so you need attention not to crush or fall down them. They can be
brocken or failed leds or cover.
3. Accessories
You should use accessories as guest of manufacturer. Ensure that there are enough
accessories in the production package before instalation.
4. Daily remainning
Unplug the power before cleaning. Firstly using wet towel to wash then cleaning again by
dry one.
Using a sponge or nonmetal soft brush to clean lens.
Step 2: Fit the camera cover to the knuckle of the sole, whirl counter-clockwise
Step 3: Connect the camera cable to the back site of Digital Video Recorder (DVR).
Signal cable connects to the BNC jack. The connection of camera cable and BNC jack
is in the image below:
INSTALLATION
Step 1: Install camera to the decided position
Drill 4 holes of the installed surface. Use 4 screws for fixing the sole to the wall surface.
If install on the wood surface, directly screw on the wood surface.
Camera has two cables: Signal cable and Power cable. Power cable connects to the
220V Power, switch to 12V for camera running. Signal cable connects to the DVR.
Step 4: After connecting camera with DVR, continuing connect to the Television or
Computer. System connection is in the chart below:
Step 1 >>
Step 4 >> Step 5 >> Step 7 >>
Step 2 >> Step 3 >>
9.5cm
7cm
3cm
1cm