Wireless EVAL Boards from RF Digital

1. • WiFi interference tolerant.
• Bluetooth interference tolerant.
• Zigbee interference tolerant.
• Build-In Antenna
• Small Size: Only 15mm x 15mm.
• Active RFID Mode
• ESN (Electronic Serial Number)
• 3 Input Logic Switch Transmitter Mode
• 3 Output Logic Switch Receiver Mode
• 9600-8N1 Serial UART Transceiver Mode
• Easy-to-use addressable network modes.
• No RF layout required.
• All features are built-in.
• Be up and running with a full wireless
solution in minutes.
• Long Range - 500 Feet (150 Meters)
• Ultra Low Power.
• Easy to hand solder or Pick & Place
automated assembly.
• Worldwide Compliant
Eval board can be powered from
it’s on-board CR2032 3V battery
or through it’s 12 pin 0.100 inch
(2.54mm) pitch header, which can
plug into directly into standard
solderless breadboards. It can work
as stand-alone remote control or
can be wired to your application
and interfaced to a controller of
your choice.