Feigeasia have a wide range of products is available that has particularly been designed to meet your requirements on gravimetric filling of containers from 1 kg to 3,000 kg. You can choose from a variety of semi-automatic and fully automatic filling machines. We can offer complete systems for fully automatic packaging processes through the combination of filling equipment with our conveyor and palletising system..http://www.feigeasia.com.sg/Conveyor_systems.html

1. Pallet Conveyor Systems And Their Models

2. To quickly get a product from one area to another, most facilities use conveyors.
Conveyors are found in many factories that use the assembly line method to order
products. However, conveyors have many uses and are not just restricted to an
assembly line production facility.

3. Pallet conveyors, also known as palletized transport systems, are used to move pallets
from one area to another for a variety of purposes and come in four styles. These
styles are the belt conveyor, roller conveyor, the chain conveyor and the cam driven.

4. All four styles have the ability to move heavily loaded pallets without much difficulty.
However, the most common styles that are used are the roller and the chain. Some will
even use a combination of the roller and the chain conveyors.

5. Roller and chain styles can be assembled to a specification that is needed. The more
standard sizes however are with the width ranging from a few inches to 12 ft and
length ranging from 5 ft and 8 ft.

6. Although it is not rare to see either of these conveyors reaching a length as high as 40
ft. The pallet conveyors are designed with a common width size of 36 inches to 60" to
accommodate the common pallet sizes. 4-gauge steel channels are used for the frames
for both styles of conveyors.

7. For the roller conveyors the rollers are constructed of 11 gauge steel and are typically
2 1/2 in diameter. The speeds will also vary with typical speeds being from 30 to 60
feet per second. For those that want it, a speed of 150 feet per second can be obtained.

8. The spacing between the rollers range from 3 inches to 12 inches. For the chain
conveyor sizes run from RC 40, 50, 60 or 80. The 80 size is the heaviest duty of the
chain conveyors. The drive of the chains is from 1/4 HP to 5 HP.

9. The horsepower motors are commonly 3 phases but a single-phase motor can be
acquired. For those that use a combination of roller and chain conveyors a cross
transfer is used.

10. This cross transfer will move the pallet 90 degrees from one style of conveyor to the
next, either starting on a roller and ending on a chain or starting on a chain and ending
on a roller. Either way the cross transfer works the same way only in reverse.

11. If moving from the rollers to chain the chain section will be lowered and when moving
from chain to roller the chain section will be raised. To keep the roller and chain pallet
conveyors moving smoothly they must be lubricated.

12. The downside with this is that build-up can occur. Build-up can cause the conveyor to
fail to move the pallets as smoothly as possible. To cut down on build-up, they should
be cleaned regularly and new lubricant placed on them. This can cut into productivity
and therefore should be preformed routinely.

13. Feigeasia Pte Ltd
Contact Us:
No. 6 Loyang Lane #02-03
Singapore - 508920
Tel : +6565464955
Fax : +6565468870
Email : feigesgp@singnet.com.sg
Web : http://www.feigeasia.com.sg/
To Order Find Out More Information On Conveyor Systems
Please Come And Visit Us Today Onwards..!