1. Possess more than 8+ years of
experience in the field of Elevator.
FUJITEC INDIA pvt.ltd. From July 16, 2015 up to present working in Erection Division,
Bangalore
Technician-FOD

Duties and Responsibilities: -



 Do the responsibility for managing to more than 100 elevators 
 Solving all erection problems and preparing to hand over. 
 Make the reports for all Erection progress and daily activities 
GULF ELEVATORS & ESCALATORS (ADWAL SAUDI ARABIA). January 09, 2010 to June 12,
2014 Erection Division, Jeddah, K.S.A
Senior Technician.

Duties and Responsibilities: -



 Test newly installed equipment to ensure that it meets specifications, such as stopping
at floors for set amounts of time. 

 Locate malfunctions in brakes, motors, switches, and signal and control systems, using
test equipment. 

 Check that safety regulations and building codes are met, and complete service reports
verifying conformance to standards. 

 Connect electrical wiring to control panels and electric motors. 

 Adjust safety controls, counterweights, door mechanisms, and components such as
valves, ratchets, seals, and brake linings. 

 Read and interpret blueprints to determine the layout of system components,
frameworks, and foundations, and to select installation equipment. 

 Inspect wiring connections, control panel hookups, door installations, and alignments
and clearances of cars and hoist ways to ensure that equipment will operate properly. 

 Disassemble defective units, and repair or replace parts such as locks, gears, cables, and
electric wiring. 

 Maintain log books that detail all repairs and checks performed. 

 Participate in additional training to keep skills up-to-date. 

2. 
 Attach guide shoes and rollers to minimize the lateral motion of cars as they travel
through shafts. 

 Operate elevators to determine power demands, and test power consumption to detect
overload factors. 

 Connect car frames to counterweights, using steel cables. 

 Bolt or weld steel rails to the walls of shafts to guide elevators, working from scaffolding
or platforms. 

 Assemble elevator cars, installing each car's platform, walls, and doors. 

 Install outer doors and door frames at elevator entrances on each floor of a structure. 

 Install electrical wires and controls by attaching conduit along shaft walls from floor to
floor, then pulling plastic-covered wires through the conduit. 

 Assemble electrically powered stairs, steel frameworks, and tracks, and install
associated motors and electrical wiring. 

 Cut prefabricated sections of framework, rails, and other components to specified
dimensions. 
KONE ELEVATOR INDIA Pvt Ltd (Under Sub Contractor) October 01, 2007 to November 21,
2009 Erection Division Technician – Kerala Trivandrum-695 001.

Duties and Responsibilities:
 Work as erector 
Assist on testing and commissioning 
 Do the service for maintenance and trouble shooting, working with Senior technician 
 Erection & Maintenance more than 25 elevators on single responsibility. 
 And responsibility for Elevator Erection 
 Make Planning to finish job on proper time. 
 And take Responsible to hand over 