This document provides instructions for building a cork shooter using craft sticks, cubes, a clothespin trigger, rubber bands, and a cork disk. The craft sticks and cubes are used to form the base and structure, a clothespin is glued on as the trigger, a rubber band is wrapped around the trigger and another attached to launch the cork disk when the trigger is released.

1. CORK SHOOTER
Firstly, attach the 3 craft sticks
with one on top of the other for
the basement of the structure by
using hot glue.
Secondly, 2 cubes are placed
close together and 1 at the end
to support the trigger. Covered
with another 3 craft sticks for the
top of the structure.
Then, the trigger (clothespin) is
glued on.

2. After that, Arubberband is
wrapped around the opening of
the clothespin so that it is harder
to open.
In forth step, the firing rubber
band is attached to the trigger.
Before that, Use a utility knife or
other tool to cut a piece of cork
into a disk shape.
Another step is use two fingers
to pull the rubberband back into
the open trigger. Close the
trigger, then let go of the
rubberband. Then, insert the cork
disk between the strands of taut
rubberband.