It is usual that the eyeglasses get broken by mistake. But you can repair them by yourself instead of buying a new pair. Here are some DIY Tips to Fix Your Broken Eyeglasses.

1. DIY Tips to Fix Your Broken Eyeglasses
Visit: www.eyeglassrepairusa.com
Eyeglasses damage is usual thing in daily life. There may be many reasons
for the breakage of glasses frames. Although, we always take care of our
eye-wear still they get broken or bend by mistake and it is very hurting
incident.
Now, most people think they have to buy a new pair of eyeglasses which will
very expensive. But there is an alternative to it, you can fix your broken or
bend glasses by yourself or take it to the repairing expert like Eyeglass
Repair USA and save your money. Because repair is always less expensive.
1 Metal Frame
2 Plastic Frame
Usually glasses frames are of three types:

2. Contact number:
(855) 726 2020
Email Address:
info@eyeglassrepairusa.c
om
Office Address: 210 E
Yelm Ave, Yelm, Wa
98597
3 Rimless Frame
How to Repair if Broken?
Fixing Metal Frame
Gently apply pressure to straighten them, avoiding breaking, using soft
pliers that have their end covered in plastic or nylon jaw chain pliers.
When the arm is the problem, warm up the metal using hot air from a
hair dryer (never open fire). Apply pressure on the nose piece if the
eyeglasses are crooked.
Bending:
Broken
frames
Only the experts can mold the metal back into shape for perfect fitting
of the lenses. So, it is better to go to an optical shop.
Fixing Plastic Frame
Bending:
Broken
frames
The same procedure used in metal frames to be applied here. Only
exception is, heating is mandatory here, exposing to the hot steam.
Use Super glue, sewing or Pin and heat technique to fix it.

3. Fixing Rimless Frame
Broken
Frames
Change the thread by inserting the wire through the small holes that the
eyeglasses have near the bridge. Thread it in and out near the bridge
and then repeat the same process on the other side, near the temple.
Once the thread is locked in, insert the lens into the frame and place
the wire onto the built-in groove. Tighten the wire to hold the lens
perfectly and then trim the extra thread.
Contact Us
210 E Yelm Ave, Yelm, Wa 98597
www.eyeglassrepairusa.com
info@eyeglassrepairusa.com
855-726-2020
Follow Us