1. Mohamed Abdel fattah Salama
Position : QC engineer
Birth date : 1st
May1989
Nationality : Egyptian
Military status : Served
Marital status : Single
Telephone : Home: 0453823047 Mobile: 01095766831
Address : El Behira – Shobrakheet – Aboyehya
E-mail : Mohamed_salama15@yahoo.com
Languages : Arabic : Mother tongue
English : Very good
 Production engineering department July 2012 Faculty of Engineering –Alexandria University.
“General Grade: good”
 Bachelor's Graduation Project :
"Application of welding in waste heat recovery project in LNG Industries"
The project discussed the overview of waste heat recovery project construction and implementation
in ELNG Company, Focusing on :
1- Piping system connects the waste heat recovery unit to the intended units.
2- Material receiving & pipe specs.
3- Codes and standards.
4- Welding technology, Wps and WQT.
5- Visual inspection and radio graphic test (RT).
The project was supervised by Egyptian liquefied Natural Gas Company (ELNG).
“Project Grade: Excellent”
Personal Data
Education

2.  ASNT NDT Level II Certification
 Summer Training: Egyptian maintenance company (QA/QC) (2011).
Alexandria Shipyard (Machining, Casting, Forming).
Industrial Training Council "ITC" (Oxyacetylene, Electric Welding).
Egyptian Swedish Welding Electrodes Co. (HEDO).
 International Welding Engineer course in Production Engineering Special Unit (welding
technology, welding metallurgy, WPS, PQR, WQT, and Welding Codes & Standards).
 Your skill … Your life course, contains (Leader ship, Time Management, and Self planning g).
under supervision of Dr/Ibrahim Elfeky.

 Gulf (Petroleum Services Company) at Khalda site in The Egyptian western desert :
QC/ Piping engineer from march 2015 till now, where I had a good knowledge about:
1- Pipe specs, pipe fittings, supports.
2- Material certificates, material requisition, material balance.
3- Piping inspection, Weld map, and As-built.
4- Became familiar with API 1104 and ASME B31.3, B16.5.
 Petrojet :
(QA&QC) Engineer for piping construction on Ethylene Project construction from July 2014
till February 2015, where I had a good knowledge about:
1- Isometric Drawing
2- Visual Inspection
3- WPS&PQR&WQT&PMI
4- Preparing (visual & PT) reports
5- Became familiar with ASME IX.
 Nagy Mix (Ready Concrete Station):
Maintenance Engineer from October 2013 till June 2014, where I had a good knowledge about :
1- Hydraulic and pneumatic systems.
2- Types of valves.
3- Reduction gearbox.
 ICDL (Ms Word, Excel, Ms Access, and Power point)
References furnished upon request.
Training and Courses
Computer Skills
Work Experience