Presentation for selection of Parameters for Motorsized 10T Bogie Turn Table, to be installed at Jhansi - to arrive at right decision by User. The presentation will be useful to Railway Engineers - for planning the Equipment for manufacturing and Maintenance of components for Railway Equipment.
Software and Systems Engineering Standards: Verification and Validation of Sy...
Bogie turn table (amin)
1. UNICRANE
UNIQUE INDUSTRIAL HANDLERS PVT.LTD.
Plant- I : E-77, MIDC, AMBAD, NASHIK
Plant-II : E-66, MIDC, AMBAD, NASHIK
Plant-III : GONDE DHUMALA
We are thankful to CWM – Jhansi Workshop
& all Officers & Supervisors
for giving us an opportunity
to give this presentation
and to discuss the changes
required in the Technical Parameters of the
BOGIE TURN TABLE
Guidance is taken from work executed by Unique Industrial Handlers Pvt. Ltd.,
literature on internet and Photos of existing installation.
2. Unique Industrial Handler Pvt. Ltd
is associated with
INDIAN RAILWAYS
SINCE 1986
Railways in India,
a sunrise industry!
Indian Railways,
a super ‘ Navaratna’.
The Indian Railways is
a global giant that
operates profitably,
effectively and with
relatively little
Government support.
13. UNIQUE INDUSTRIAL HANDLERS PVT.LTD.
CHANGES PROPOSED FOR BOGIE TURN TABLE
THRUST BEARING AND SELF ALIGNED BEARING PROVIDED ON CENTER PIVOT TO
SUSTAIN THE (70 TO 90 % DEPENDING ON POSTION OF BOGIE ON TURN TABLE
14. UNIQUE INDUSTRIAL HANDLERS PVT.LTD.
CHANGES PROPOSED FOR BOGIE TURN TABLE
DRIVE IS GIVEN BY COMPACT GEARED MOTOR INSTALLED ABOVE THE FLOOR LEVEL
15. UNIQUE INDUSTRIAL HANDLERS PVT.LTD.
PROJECTIONS ABOVE FLOOR LEVEL
CONTROL PANEL & COMPACT GEARED MOTOR WILL BE INSTALLED ABOVE THE FLOOR LEVEL
16. UNICRANE
UNIQUE INDUSTRIAL HANDLERS PVT.LTD.
B R I E F
We need to confirm following after discussion:
1) WATER LEVEL DURING HEAVY RAIN IN THE AREA – WILL NOT
EXCEED + 50 MM
2) SUGGESTION – IF ANY FOR WATER DISCHARGE SYSTEM - PUMP
WILL BE LOCATED INSIDE THE PIT.
3) DRAWING FOR EXISTING DRAINAGE SYSTEM REQUIRED TO
WATER TANKS TO CONNECT THE WATER DRAINED TO EXISTING
SYTEM.
4) HEIGHT RESTRICTION – IF ANY FOR INSTALLATION OF COMPACT
GEARED MOTOR.
5) LOCATIONS OF CONTROL PANELS – TO PLAN THE CABLES
REQUIRED & LOCATION OF LIMIT SWITCHES / MANUAL LOCKS –
PREFERENCE – IF ANY.
6) ANY OTHER POINTS AS RAISED DURING DISCUSSION.