I am the authorized K-12 representative in South Carolina for eInstruction by Turning Technologies
Bill McIntosh
SchoolVision Inc..
Authorized South Carolina K-12 Consultant for eInstruction / Turning Technologies
Phone :843-442-8888
Email :WKMcIntosh@Comcast.net
Twitter : @OtisTMcIntosh
SchoolVision Website on Facebook: https://www.facebook.com/WKMIII
Website : www.einstruction.com
For technical assistance on all eInstruction® or Turning Technologies products please call 866-746-3015
Turning Technologies | 255 West Federal Street | Youngstown, OH Main: 330-746-3015 | Toll Free: 866-746-3015 | Fax: 330-884-6065
www.TurningTechnologies.com
Call Girls in Dwarka Mor Delhi Contact Us 9654467111
Wireless kit for touch board plus
1. Wireless Kit for Touch Board Plus 1
WIRELESS KIT FOR TOUCH BOARD PLUS
Turning Technologies Device Manager version 7.3 or higher must be installed on your computer prior to installing the Wireless
Kit.
Device Manager is automatically installed with the following software: WorkSpace (v.9.4) and Flow (v.2.0).
The MultiHub plugs into a USB port on your computer or a powered USB Hub. The RFCOM (Radio Frequency Communicator)
plugs into a wall outlet while positioned in the RFCOM clip that slips over the frame at the side of the Touch Board.
Connecting the Touch Board Plus
Turning Technologies Device Manager version 7.3 or higher must be installed on your computer prior to installing the Wireless
Kit.
The MultiHub plugs into a USB port on your computer or a powered USB Hub. The RFCOM (Radio Frequency Communicator)
plugs into a wall outlet while positioned in the RFCOM clip that slips over the frame at the side of the Touch Board Plus.
1 Slide the plastic gray clip over the frame at the side of the Touch Board Plus.
2 Seat the RFCOM into the plastic gray clip.
3 Connect the appropriate end of the power cord into the power cord terminal and the opposite end into a nearby wall
outlet.
4 Connect the USB cable from the Touch Board Plus to the RFCOM .
5 Turn on the RFCOM power switch . The amber light will turn on to show a successful connection to the Touch
Board Plus.
6 Plug the MultiHub into a working USB port on your computer or a powered USB hub.
7 Press the pairing button on the MultiHub. The blue light will begin to blink.
8 Press the pairing button on the RFCOM.
IMPORTANT
You have two minutes to press the pairing button.
When the two devices have been successfully paired, the blue light on the RFCOM will stop blinking and remain a solid
blue. The light will dim when connection to the MultiHub is lost.
Pairing the device is a one-time operation.
turningtechnologies.com/user-guides