ENGINEERING THERMODYNAMICS ANNA UNIVERSITY QUESTION PAPER MAY 2011

1. Reg. No. :
B.E./B.Tech. DEGREE EXAMINATION, APRIL/MAY 2011
Third Semester
Mechanical Engineering
ME 2202 — ENGINEERING THERMODYNAMICS
(Regulation 2008)
(Common to PTME 2202 Engineering Thermodynamics for B.E (Part-Time)
Mechanical Engineering Third Semester - Regulation 2009)
Time : Three hours Maximum : 100 marks
Answer ALL questions
PART A — (10 × 2 = 20 marks)
1. Calculate the actual pressure of air in the tank if the pressure of
compressed air measured by manometer is 30 cm of mercury and
atmospheric pressure is 101 kPa. (Take g = 9.78 m/s2
)
2. What is meant by ‘Hyperbolic Process’?
3. List out the generic types of irreversibilities.
4. State : Carnot Theorem and Its Corollaries.
5. What do you understand from the word ‘Dryness fraction’?
6. What are the ways by which Rankine cycle efficiency may be improved?
7. State : Dalton’s law of partial pressures.
8. What do you mean by ‘‘Compressibility factor’’?
9. Define : Relative humidity.
10. What do you understand from the ‘‘Dew point temperature’’?
Question Paper Code : 11403
10
8
10
8
10
8
BIBIN.C / ASSOCIATE PROFESSOR / MECHANICAL ENGINEERING / RMK COLLEGE OF ENGINEERING AND TECHNOLOGY

2. 114032
PART B — (5 × 16 = 80 marks)
11. (a) A gas contained in a cylinder is compressed from 1 MPa and 0.05 m3
to
2 MPa. Compression is governed by
4.1
V
P constant. Internal energy of
gas is given by; kJ.425,PV7.5U −= where P is pressure in kPa and V
is volume in m3
. Determine heat, work and change in internal energy
assuming compression process to be quasistatic. Also find out work
interaction, if the 180 kJ of heat is transferred to system between
same states.
Also explain why it is different from above? (16)
Or
(b) In a gas turbine installation air is heated inside heat exchanger up to
C750 o
from ambient temperature of C27 o
. Hot air then enters into
gas turbine with the velocity of 50 m/s and leaves at C600 o
. Air
leaving turbine enters a nozzle at 60 m/s velocity and leaves nozzle
at temperature of C500 o
For unit mass flow rate of air determine the
following assuming adiabatic expansion in turbine and nozzle, (16)
(i) Heat transfer to air in heat exchanger
(ii) Power output from turbine
(iii) Velocity at exit of nozzle.
Take up for air as 1.005 kJ/kgo
K.
12. (a) A reversible heat engine operates between two reservoirs at C827 o
and C27 o
. Engine drives a Carnot refrigerator maintaining C13 o
−
and rejecting heat to reservoir at C27 o
. Heat input to the engine is
2000 kJ and the net work available is 300 kJ. How much heat is
transferred to refrigerant and total heat rejected to reservoir at
C27 o
? (16)
Or
(b) (i) How do you differentiate the Exergy (Availability) and energy
based upon their characteristics? (4)
(ii) Determine the rate of power loss due to irreversibility in a heat
engine operating between temperatures of 1800 K and 300 K.
Engine delivers 2 MW of power when heat is added at the rate of
5 MW. (12)
10
8
10
8
10
8
BIBIN.C / ASSOCIATE PROFESSOR / MECHANICAL ENGINEERING / RMK COLLEGE OF ENGINEERING AND TECHNOLOGY

3. 114033
13. (a) In a closed vessel the 100 kg of steam at 100 kPa, 0.5 dry is to be
brought to a pressure of 1000 kPa inside vessel. Determine the mass
of dry saturated steam admitted at 2000 kPa for raising pressure.
Also determine the final quality. (16)
Or
(b) A steam power plant running on Rankine cycle has steam entering HP
turbine at 20 MPa, C500 o
and leaving LP turbine at 90% dryness.
Considering condenser pressure of 0.005 MPa and reheating
occurring up to the temperature of C500 o
determine, (16)
(i) The pressure at which steam leaves HP turbine
(ii) The thermal efficiency.
(iii) Work done.
14. (a) In 5 kg mixture of gases at 1.013 bar and 300 K the various
constituent gases are as follows, 80% N2, 18% O2
, 2% CO2
. Determine
the specific heat at constant pressure, gas constant for the
constituents and mixture and also molar mass of mixture taking
4.1=γ for N2
and O2
and 3.1=γ for CO2
. Universal gas constant =
8314 J/kg.K . (16)
Or
(b) Derive the Clausius Clapeyron equations and Vander Waal’s
equations.
(16)
15. (a) For the atmospheric air at room temperature of C30 o
and relative
humidity of 60% determine partial pressure of air, humidity ratio,
dew point temperature, density and enthalpy of air. (16)
Or
(b) Two streams of moist air, one having flow rate of 3 kg/s at C30 o
and
30% relative humidity, other having flow rate of 2 kg/s at C35 o
and
85% relative humidity get mixed adiabatically. Determine specific
humidity and partial pressure of water vapour after mixing.
Take ,CP Stream = 1.86 kJ/kg.K. (16)
————––––——
10
8
10
8
10
8
BIBIN.C / ASSOCIATE PROFESSOR / MECHANICAL ENGINEERING / RMK COLLEGE OF ENGINEERING AND TECHNOLOGY