Maintaining a swimming pool is essential to keep it clean and safe for use, involving several steps like skimming debris, vacuuming, adjusting chemicals, and cleaning filters. Key maintenance techniques include proper vacuuming methods, chemical adjustments for pH and chlorine, and backwashing different types of filters. Regular upkeep makes enjoying a pool more enjoyable and less of a burden.

2. On a searing summer day, a swimming pool is a welcome respite from the heat. But
before you can dive into its cool blue water, you have to perform all the
maintenance drudgery that prolongs its crystal-clear perfection. This often makes
a backyard pool more of a burden than a blessing. Here are some of the techniques
used to speed up the process and create a safe, refreshing swimming pools.

3. Step 1: Get Rid of Debris
Skimming the surface of the pool for floating debris and emptying the skimmer
basket takes just a minute or two. Dispose of this waste away from the pool so it
can't blow back into the water or be tracked back into the area.

4. Step 2: Set Up the Vacuum
Direct the nozzles of the return jets on the pool sides downward to quiet surface
ripples so you can see the bottom clearly. After connecting the vacuum to the hose,
prop up the pole with the vacuum head suspended over the water. Then use one of
the jet nozzles to fill the free hose end until the water pours out the vacuum.

5. Step 3: Vacuum the Pool
The average pool requires 30 minutes of vacuuming. Move slowly across the water
in overlapping parallel lines, like mowing a lawn. If the pool is too wide for one
pass, vacuum half at a time. Watch for a floating hose, which indicates a hole in the
line, or diminshed suction due to a full filter. Complete the cleaning by brushing
any algae off the pool sides with a nylon brush on the vacuum pole. For concrete
use a stainless steel brush.

6. Step 4: Adjust the Chemicals
Test and correct pool chemistry weekly. Adjust pH first—with muriatic acid if it's
above 7.6 or with soda ash product if it's under 7.4. If the chlorine is below 1 part
per million (ppm) or alkalinity is less than 90 ppm, "shock" the water: Dissolve
chlorine and/or alkalinity increaser (baking soda works in a pinch) in a bucket of
water and toss in.

7. Step 5: Backwash the Filter
Turn the filter valve to "backwash" to redirect water flow. Most pools use one of
three kinds of filter: sand, diatomaceous earth (DE), or cartridge. In a sand filter—
no longer used in new construction—sand blocks dirt and oil; the backwash
directs the dirty water to a waste line leading to the ground or a storm drain. With
a DE filter, the claylike remains of marine organisms do the filtering and the
backwash directs the dirt into a filter bag.

8. Step 6: Clean the Pump Filter
Clean out the hair/lint catcher in the pump next. First, shut the system off, then
close the skimmer valve in front of the pump to hold the water in place so the
system won't need repriming when it starts up again. Unscrew the trap's cover and
remove the basket, emptying it into the garbage.

9. Step 7: Add Chlorine to the System
If you have a chlorinator, a tubelike tank next to the filter, it's a great way to
introduce chlorine—in the form of slow-dissolving sticks—into your pool. You can
also use a floating container, but it can be a danger if small children get their hands
on it.

10. Swimming Pool @ Your Backyard
Call 0413 747 412 Today
Custom
Swimming Pools
Swimming Pools
Renovation
Custom Spa Pools
Swimming Pools
Landscaping