The document discusses engineering initiatives using 3D modeling software to extract 2D duct detail drawings and arrange duct models for clash detection with structural members. The software, Tekla, was adapted for plate modeling and successfully generated duct arrangement drawings from 3D models. Integrating structure and duct models in Tekla allowed for clash checks of ducts with structural elements during implementation in a 3*660MW power plant weighing 1300 tons. Key benefits of using Tekla for duct detailing included enhanced 3D visualization, error-free bills of material, reduced cycle times while improving output quality, and more clarity in duct-wise drawings.
Optimization of Electrical Machines in the Cloud with SyMSpace by LCMcloudSME
Presented at NAFEMS DACH regional conference for numerical simulation methods by LCM and cloudSME in Wiesbaden on the 14th of November 2019.
The Linz Center of Mechatronics GmbH showcased how they easily optimize electrical drive engines in the cloud.
We supported LCM to work out the right cloud-based service solutions for their customers based on their existing software. By respecting the latest developments in the industry and science, including security and privacy compliance and hosting flexibility (free choice of data centre, no vendor lock-in).
Check out their cool System Model Space "SyMSpace" for electrical drive engines and trusted by industrial partners! (https://bit.ly/2CKGphb) #poweredbycloudSME
Yes, Cloud Computing is offering a broad range of actions and can be confusing. You want to dig deeper?
Write us an email or give us a call so that we can work out how to approach the perfect cloud solution for your needs.
There is approximately a 20% savings cost for using rolled threads instead of cut thread rods. Per ACI 318 Section D, there is no capacity difference between the two methods of manufacturing when used as anchor bolts set in concrete.
Optimization of Electrical Machines in the Cloud with SyMSpace by LCMcloudSME
Presented at NAFEMS DACH regional conference for numerical simulation methods by LCM and cloudSME in Wiesbaden on the 14th of November 2019.
The Linz Center of Mechatronics GmbH showcased how they easily optimize electrical drive engines in the cloud.
We supported LCM to work out the right cloud-based service solutions for their customers based on their existing software. By respecting the latest developments in the industry and science, including security and privacy compliance and hosting flexibility (free choice of data centre, no vendor lock-in).
Check out their cool System Model Space "SyMSpace" for electrical drive engines and trusted by industrial partners! (https://bit.ly/2CKGphb) #poweredbycloudSME
Yes, Cloud Computing is offering a broad range of actions and can be confusing. You want to dig deeper?
Write us an email or give us a call so that we can work out how to approach the perfect cloud solution for your needs.
There is approximately a 20% savings cost for using rolled threads instead of cut thread rods. Per ACI 318 Section D, there is no capacity difference between the two methods of manufacturing when used as anchor bolts set in concrete.
1. ENGINEERING INITIATIVES
3-D MODELING AND EXTRACTION OF 2-D DUCT DETAIL DRAWINGS
FROM TEKLA STRUCTURES
• Tekla is a special purpose 3D software used for structural detailing
• The software has been adapted to suit plate modelling and duct arrangement and detail drawings
were successfully extracted from 3D model.
2. ENGINEERING INITIATIVES
DUCT ARRANGEMENT- INTEGRATION OF
STRUCTURE AND DUCT MODELS FOR
CLASH CHECK WITH STRUCTURAL
MEMBERS
IMPLEMENTED IN NABINAGAR 3*660MW
WEIGHT: 1300 TONS
3. ENGINEERING INITIATIVES
ADVANTAGES OF USING TEKLA SOFTWARE FOR DUCT DETAILING:
Advantages
3D VIEW ENHANCES
PRODUCT
VISUALISATION
NIL ERROR IN
AUTOMATED, BOM
AND DESPATCH
TABLE
REDUCED CYCLE TIME
WITH INCREASED
QUALITY OF OUTPUT
DU WISE DRAWINGS-
MORE CLARITY
TEKLA 3D DUCT ARRANGEMENT MODEL
