1. The document provides tolerance information for Okw injection molded plastic parts and machined parts. For plastic parts, DIN 16742 tolerance group 6 applies, allowing for deviations from nominal dimensions. 2. For injection molded plastic parts, the allowable tolerances range from ±0.07mm to ±3.1mm depending on the nominal dimension. Tolerances also distinguish between dimensions that are tool-specific (W) and not tool-specific (NW). 3. For machined, printed, or cut parts under 30mm, tolerances are ±0.3mm from the reference edge. Larger dimensions follow DIN ISO 2768m T1 tolerances unless otherwise specified.