The document provides instructions for installing a GeoLok locking device on a shipping container. It explains that the lock must be in an "unlocked" and "unlatched" condition before installation. It describes how to verify the lock is unlatched by squeezing the latch release against the carry handle to open the latch. It also describes how to check if the lock is unlocked by pushing in the square drive socket, and if it does not push in then a valid unlock code is needed to proceed.

1. GeoLok ® Operation Training Locking & Latching Start

2. ! Before you start Before attempting to install your GeoLok on a shipping container, the Lock must be “Unlocked” and “Unlatched” . Locking & Latching Next

3. ! Before you start Verify an “Unlatched” condition by squeezing the Latch Release Latch Release Carry Handle Locking & Latching Next

4. ! Before you start Locking & Latching Squeezing the Latch Release against the Carry Handle opens the Latch. Next

5. ! Before you start Locking & Latching Square Drive Verify an “Unlocked” condition by pushing in the Square Drive Socket If the Square Drive will not push in, the Lock is in a “Locked” condition; a valid Unlock code is needed before proceeding. Next