Pass your 300-360 exam in first attempt with the help of our dumps.Examcollection have the best study material for all CISCO exam. now your success is guaranteed.for more info just visit us. http://www.examcollection.us/300-360-vce.html

2. Easy and Effective Study
Material
Examcollection offered you best and
effective study content that helps you to
get prepare your exam
http://www.examcollection.us/300-360-vce.html

3. CISCO 300-360 Exam Features
http://www.examcollection.us/300-360-vce.html
• Quality & Value
• Verified Answers by Experts
• 100% Pass Guarantee
• Based on real Exam scenerio
• Money Back Assurance

4. Questions Answers Section
http://www.examcollection.us/300-360-vce.html

5. Q # 1
http://www.examcollection.us/300-360-vce.html
Which two types of information must be included in the installation
inventory portion of the post-installation report? (Choose two.)
A. all AP, controller, and MSE administrator credentials
B. the names, locations, IP addresses, MAC addresses, etc. for every
AP, controller, and MSE in the WLAN
C. a layout of the rack that the equipment is installed
D. results of the coverage audit performed with the site survey
mapping tool
E. the number and type of all WLAN clients and tags
Answer: A, B

6. Q # 2
http://www.examcollection.us/300-360-vce.html
An engineer plugs in a Cisco Aironet 2700 Series Access Point and it
is running in low power. Which three power requirements should be
verified? (Choose three.)
A. 802.3ac compliant
B. 802.3at compliant
C. AP requires 43 VDC to function in full power.
D. AIR-PWRINJ3 power injector should be used.
E. AP requires 57 VDC to function in full power.
F. AIR-PWRINJ4 power injector should be used.
Answer: B, E, F

7. Q # 3
http://www.examcollection.us/300-360-vce.html
An 802.11n implementation is being discussed. Users are satisfied with
the potential 300-450 Mbps throughput of new 802.11n APs. Which three
bandwidth requirements are used to calculate per client bandwidth
through an 802.11n AP network? (Choose three.)
A. 450 Mbps throughput is the client max for 5-GHz radio.
B. Channel bonding on 5 GHz is required for a client to have a 300 Mbps
WiFi link.
C. 300 Mbps throughput is the client max for 2.4-GHz radio.
D. The remaining bandwidth is divided per device when more clients are
connected to one AP.
E. 100 Mbps Ethernet switch port is a potential bottleneck.
F. CleanAir helps clear noise for 802.11n channel bonding to work.
Answer: A, C, E

8. Q # 4
http://www.examcollection.us/300-360-vce.html
As part of a wireless site survey in a hospital, an engineer needs to
identify potential Layer 1 interferers. In which three areas is the
engineer most likely expect to find sources of 2.4 GHz and 5 GHz RF
noise? (Choose three.)
A. emergency room
B. magnetic resonance imaging
C. laboratory
D. X-ray radiography
E. Gamma Knife radiation treatment
F. kitchen
Answer: A, C, F

9. Q # 5
http://www.examcollection.us/300-360-vce.html
What is the recommended minimum speed at the edge of the cells in an
802.11g network for a good Cisco VoWLAN deployment?
A. 11 Mb/s
B. 36 Mb/s
C. 12 Mb/s
D. 18 Mb/s
Answer: C

10. Q # 6
http://www.examcollection.us/300-360-vce.html
An engineer is installing a wireless network in an industrial area with
extreme temperatures and a significant amount of dust. Which enclosure
should be used to protect the APs?
A. ACU
B. ADU
C. NEMA
D. WLSE
Answer: C

11. Q # 7
http://www.examcollection.us/300-360-vce.html
Which three recommendations must be taken into consideration when an
engineer is installing a new Voice WLAN? (Choose three.)
A. Use the Cisco wireless phone site survey client utility.
B. Use a separate Cisco Wireless Lan Controller.
C. Enable load balance on voice WLANs.
D. Maintain -67dBM as a minimal RSSI.
E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
F. Enable lower data rates for 2.4-GHz data WLAN.
Answer: A, D, E

12. Q # 8
http://www.examcollection.us/300-360-vce.html
A Cisco 7925 phone at a client’s location is not registering with CUCM.
The engineer analyzes a packet capture, sees that the phone receives an
IP, and downloads the proper configuration file from TFTP successfully.
What type of messages should the phone be sending at this point?
A. H.245
B. H.323
C. MCGP
D. SCCP
Answer: D

13. Q # 9
http://www.examcollection.us/300-360-vce.html
What are two advantages of conducting an active survey versus a passive
survey when verifying RF coverage? (Choose two.)
A. verifies packet loss
B. verifies roaming
C. verifies SNR
D. verifies signal level
E. verifies interferers
Answer: A, B

14. Q # 10
http://www.examcollection.us/300-360-vce.html
An engineer is determining the signal levels for the wireless cells. Which
signal-to-noise ratio is an optimal configuration to achieve?
A. minimum SNR of -33 dBm
B. minimum SNR of -25 dBm
C. minimum SNR of 25 dB
D. minimum SNR of 33 dB
Answer: C

15. Get A complete file from here
http://www.examcollection.us/300-360-vce.html