Ecway Technologies provides engineering projects and software development with offices across multiple cities in India. They design and fabricate multi-purpose V-type hydraulic angle forming machines. These machines use hydraulic systems to transfer energy and apply force for metal forming operations that require heavy pressures and intricate shaping. The hydraulic drive applies force via a piston and cylinder to clamps that hold and shape metal between male and female dies. Key advantages are using low-cost energy and ability to form complex shapes easily, though periodic maintenance and cost of hydraulics are disadvantages.

1. ECWAY TECHNOLOGIES
IEEE PROJECTS & SOFTWARE DEVELOPMENTS
OUR OFFICES @ CHENNAI / TRICHY / KARUR / ERODE / MADURAI / SALEM / COIMBATORE
BANGALORE / HYDRABAD
CELL: +91 98949 17187, +91 875487 1111 / 2111 / 3111 / 4111 / 5111 / 6111 / 8111
VISIT: www.ecwaytechnologies.com | www.ecwayprojects.com
Mail to: ecwaytechnologies@gmail.com | ecwayembedded@gmail.com
DESIGN AND FABRICATION OF MULTI PURPOSE
V- TYPE HYDRAULIC ANGLE FORMING MACHINE
SYNOPSIS
A hydraulic fluid power system is defined as a means of power
transmission
in which relatively incompressible fluid is used as the power
transmitting media. The primary purpose of hydraulic system is the transfer of
energy from one location to another location and this energy into useful work.
In this project fabricated model of MULTIPURPOSE HYDRAULIC
FORMING MACHINE will describe the working principles as well as hydraulic
machines application and its advantages. Metal forming can be defined as a
process in which the desired and shape are obtained through the deformation of
metals plastically under the action of externally applied force. The type of drive
depends upon the length of the stroke needed and loaded on the ram. In this project
we have selected applied to the hydraulic force for the angle forming machine.
The Hydraulic drive is used when a very heavy pressures is required on the ram
this is used for drawing and forming operation .System pressure can be generated
in the form of any physical action which result a compression over the Hydraulic
system.

2. Pascal’s Law:
Pascal’s law states that the pressure applied anywhere to a confined liquid it
transmitted equally to every portion of the surface of the containing vessel.
Refer the following fig. When a force is applied to the liquid by a piston, the liquid
transmits this force equally to all surfaces of the container.
FABRICATION OF ANGULAR SHEET FORMING
MACHINE
PULLER
CLAMP
JOB
FEMALE
DIE
MALE DIE
PISTON
CYLINDER
PULLER
BAR
BASE

3. Advantage
1. The process uses low- cost energy source
2. Large machines frames are not required on the process
3. Intricate shapes on material of low form ability can be worked fairly easily.
Disadvantage
1) Periodic maintenance is needed
2) Hydraulic accessories are costly