Connecting Spooky Boost v3.0

Spooky2
Connecting Spooky Boost v3.0
Our Users & Team

Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Spooky Boost v3.0 connects directly to OUT1 and OUT2 of
your XM generator.

Colloidal Silver
Connect the lead that came with your generator to the Colloidal Silver output of
Spooky Boost v3.0. Attach the clips to the 2 silver rods. The rods should be
approximately 1 inch apart. Full instructions can be found in the Spooky User's
Guide.

Spooky Boost (Bio North)
Spooky Remote BN connects directly to the BN output connector of Spooky
Boost v3.0.

Spooky Boost (Magnetic North)
Spooky Remote MN connects directly to the MN output connector of Spooky
Boost v3.0.

Spooky Boost v1.0
You may attach Spooky Boost v1.0 to Spooky Boost v3.0 using the 2 top
OUT1 and OUT2 connectors.
Spooky Remote BN – Blue to OUT1.Red to OUT2.
Spooky Remote MN – Red to OUT1. Blue to OUT2.

You can also run 2 boosted remotes simultaneously, but this is not
recommended. The performance will be reduced for each remote. Do not run
Spooky Remote BN and Spooky Remote MN from the same generator.

Thank you!

Connecting Spooky Boost v3.0

More Related Content

Similar to Connecting Spooky Boost v3.0

More from Spooky2 Rife

Recently uploaded

Connecting Spooky Boost v3.0