1. Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#router eigrp 10
Router(config-router)#network 130.40.22.0 0.0.0.255
Router(config-router)#network 130.40.23.0 0.0.0.255
Router(config-router)#network 130.40.20.0 0.0.0.255
Router(config-router)#network 200.10.10.10 0.0.0.3
Router(config-router)#network 200.10.10.17 0.0.0.3
Router(config-router)#end
Router#
%SYS-5-CONFIG_I: Configured from console by console
w
Building configuration...
[OK]
summarizacion....
Router>ena
Router#config
Configuring from terminal, memory, or network [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#int
Router(config)#interface s0/0/0
Router(config-if)#ip summary-address eigrp 10 130.40.20.0 255.255.252.0
Router(config-if)#
%DUAL-5-NBRCHANGE: IP-EIGRP 10: Neighbor 200.10.10.9 (Serial0/0/0) is up: new
adjacency
%DUAL-5-NBRCHANGE: IP-EIGRP 10: Neighbor 200.10.10.18 (Serial0/0/1) is up: new
adjacency
Router(config-if)#exit
Router(config)#int
% Incomplete command.
Router(config)#interface s0/0/1
Router(config-if)#ip summary-address eigrp 10 130.40.20.0 255.255.252.0
Router(config-if)#
%DUAL-5-NBRCHANGE: IP-EIGRP 10: Neighbor 200.10.10.18 (Serial0/0/1) is up: new
adjacency
%DUAL-5-NBRCHANGE: IP-EIGRP 10: Neighbor 200.10.10.9 (Serial0/0/0) is up: new
adjacency
end
Router#
%SYS-5-CONFIG_I: Configured from console by console
w
Building configuration...
[OK]
Router#