1. ECWAY TECHNOLOGIES
IEEE PROJECTS & SOFTWARE DEVELOPMENTS
OUR OFFICES @ CHENNAI / TRICHY / KARUR / ERODE / MADURAI / SALEM / COIMBATORE
BANGALORE / HYDRABAD
CELL: +91 98949 17187, +91 875487 1111 / 2111 / 3111 / 4111 / 5111 / 6111 / 8111
VISIT: www.ecwaytechnologies.com | www.ecwayprojects.com
Mail to: ecwaytechnologies@gmail.com | ecwayembedded@gmail.com
AUTOMATIC CLUTCH & BRAKING SYSTEM
ABSTRACT
This project is used to protect the car from accident or interrupt the compare
ness of driving a car. The figure shows the Functional Diagram of Automatic
Clutch and braking system implementing by Micrcontroller.
It’s consists of
Interrupt sensor, controlling unit and main part of Micro controller.
IR sensor is used to detect the interrupt the car is sensed through IR sensor,
its called optical sensor.
The interrupt sensing output is send to the Micro
controller. Micro controller is a general-purpose device and is used for control
purpose using a fixed program that is stored in EPROM. The Micro controller
design uses a much more limited set of single byte and double byte instructions
that set of single byte and double byte instructions that are used to move data and
code from internal memory to ALU.
2. Micro controller reads the status of input and takes decision according to the
Assembly Language program stored in Micro controller. The output from the
controller is fed to a relay driver, which can be used to drive the relays, due to
energize, and de energize of relays. The DC motor is connected with this relay is
getting On/Off for motor rotate forward and reverse direction to control the clutch
and brake mechanism. Thus we can automatically control the clutch and brake by
using Micro controller.
3. Functional Diagram:
64KB RAM
RELAY
DRIVER &
RELAY
IR SENSOR
Micro
Controller
DC
MOTORS
CLUTCH
BRAKE
ADVANTAGES
It requires simple maintenance cares
The safety system for automobile.
Checking and cleaning are easy, because of the main parts are screwed.
Easy to Handle.
Low cost automation Project
Repairing is easy.
Replacement of parts is easy.
DISADVANTAGES
Initial cost is high.
