10. Flat Pattern Making
4/18/2020
Classic Shaping ofWaist
1) Back Dart = 3.5 cm. (1.75 cm on either
side of the dotted line at 18. Shape up
to 17.
2) From 33 Move 1.5 cm inwards to Center
Back (CB) . Join 32 to this new point
and shape side seam to waist.
3) Front Dart = 4.5 cm. (2.25 cm on either
side of the dotted line at 24. Shape up
to .5 â 1 cm below 26.
4) From 33 Move 2.5 cm inwards to Center
Front (CF) . Join 32 to this new point
and shape side seam to waist.
STEPS OF CONSTRUCTION:
17. Flat Pattern Making- Introduction
Shaping of Waist
4/18/2020ProfSG.Babu
1) Trace the Close fitting block up to Hip
line.
2) Draw classic waist shaping ( as
discussed before).
3) Except Moving down by 1 cm and
shaping with a curved line
4) Marks Point 1,2,3,4.
Ă
STEPS OF CONSTRUCTION:
18. Flat Pattern Making- Introduction
Shaping of Waist
4/18/2020ProfSG.Babu
1) Trace the Close fitting block up to Hip
line.
2) Draw classic waist shaping ( as
discussed before).
3) Marks Point 1,2,3,4.
Ă
STEPS OF CONSTRUCTION:
Close Fitting Block
Up to Hip line
Waist Shaping
19. Flat Pattern Making- Introduction
4/18/2020ProfSG.Babu
1) Square Down from 1 â 5 and 4 â 6.
1-5 is full length of the Dress, Square
Across.
2) 7 is midpoint between 5 and 6, Square
up to meet the Hip line and mark it 8.
3) Join 2-8 and 3-8 with curved lines.
4) Extend Back dart by 13 cm and front
dart by 11 cm.
STEPS OF CONSTRUCTION: